Vehicle Side Slip Angle Observation with Road Friction Adaptation
نویسندگان
چکیده
منابع مشابه
Design on Adaptive Fuzzy Observer of Vehicle Side Slip Angle
A novel observer structure for vehicle side slip angle (β ) estimation is proposed, in which a local approximation of the nonlinear tire model is adopted. Fuzzy logic approach is adopted to combine the local observer models so as to deal with the nonlinear nature of vehicle dynamics. The derivation of observer’s state equations and the estimation mechanism is developed. By choosing the membersh...
متن کاملSlip Angle Observer of the Vehicle Body Side
Usually, a reduced car model contains only the state variables ( speed, body side slip angle and yaw rate), which are essential for the vehicle dynamic and ABS control. When certain of these state variables cannot be measured, observers are implemented without unacceptable expenses. Since in this case the system is a non-linear one, a Luenberger observer is not possible directly to be used. In ...
متن کاملNonlinear Observer for Vehicle Velocity with Friction and Road Bank Angle Adaptation – Validation and Comparison with an Extended Kalman Filter
Many active safety systems in automotive vehicles, for instance yaw stability systems such as ESC/ESP, depend on information about vehicle velocity, in particular lateral velocity or side-slip angle, to be able to function properly. However, the vehicle velocity is rarely measured directly due to issues of cost and reliability, and must therefore in general be inferred from other measurements, ...
متن کاملSlip-based Estimation of Tire|road Friction
An approach to estimate the tire{road friction during normal drive using only the wheel slip, that is, the relative diierence in wheel velocities, is presented. The driver can be informed about the maximal friction force and be alarmed for sudden changes. Friction related parameters are estimated using only signals from standard sensors in a modern car, and the physical relation between these p...
متن کاملSlip-based tire-road friction estimation
Tire-road friction is estimated using the wheel-slip computed from standard sensor signals. A parametric model is estimated using an adaptive lter supported by a fault detector. Results from extensive eld trials are presented. An approach to estimate the tire{road friction during normal drive using only the wheel slip, that is, the relative diierence in wheel velocities, is presented. The drive...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IFAC-PapersOnLine
سال: 2017
ISSN: 2405-8963
DOI: 10.1016/j.ifacol.2017.08.593