Very High Pressure Hot Pressing of Oxidized Silicon Nitride Powders without Additives
نویسندگان
چکیده
منابع مشابه
Argon-shielded hot pressing of titanium alloy (Ti6Al4V) powders.
The paper presents the method of the argon - shielded hot pressing of titanium alloy (Ti6A14V) powder (used in medical industry). The powders produced in the GA (gas atomization) process and in the HDH (hydride - dehydride) process were used in the experiments. A pressing process was conducted at a temperature of 800-850 degrees C for different lengths of time. An unoxidized sintered material, ...
متن کاملLow Temperature Sintering Additives for Silicon Nitride
This work deals with sintering additives for the low temperature pressureless sintering of Si3N4, via a transient liquid technique. Much attention has been given to the development of a sintering process using low-cost Si3N4 powder (Silzot HQ, Germany) as the starting material and employing sintering additives which are also both economically attractive and enable sintering at low temperatures....
متن کاملStudies on Atmospheric Ageing of Nanosized Silicon Nitride Powders
Ageing of nanosized silicon nitride powder produced by the vapor phase reaction of silicon tetrachloride and ammonia has been studied in argon gas, in dry air and in air of 80% humidity, respectively, for 3 to 540 days. No remarkable changes were observed either in the bulk or the surface properties on storage in argon gas for 90 days. However, samples stored in dry air and humid air, respectiv...
متن کاملYield Strength of a-Silicon Nitride at High Pressure and High Temperature
Through the analysis of peak broadening of energy-dispersive diffraction lines from a powdered sample, the yield strength of a-Si3N4 was investigated at a pressure of 9 GPa and temperatures up to 12341C. During compression at room temperature, the lattice strain deduced from peak broadening increased linearly with pressure up to 9.2 GPa, with no clear indication of strain saturation. While heat...
متن کاملInvestigation of attractive forces between PECVD silicon nitride microstructures and an oxidized silicon substrate
A troublesome phenomenon encountered durmg the reahzatlon of free-standmg mlcrostructures, for example, beams, diaphragms and micromotors, IS that mltlally released structures afterwards stick to the substrate This effect may occur durmg wafer drying after the etching process has been completed, as well as during normal operation as soon as released structures come mto contact with the substrat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Association, Japan
سال: 1987
ISSN: 1884-2127,0009-0255
DOI: 10.2109/jcersj1950.95.1098_240