Vibration Isolator Using Air Suspensions with Slit Restrictions
نویسندگان
چکیده
منابع مشابه
Vibration of Road Vehicles with Non linear Suspensions
In order to investigate the effects of non-linear springs in vibrating behavior of vehicles, the independent suspension of conventional vehicles could be modeled as a non-linear single degree of freedom system. The equation of motion for the system would be a non-linear third order ordinary differential equation, when considering the elasticity of rubber bushings in joints of shock absorber. It...
متن کاملMechatronic Vibration Isolator for the Microtechnics with Real-time Interaction
A mechatronic vibration isolation system has been developed on the basis of system theory. This equipment integrates mechanics, pneumatics and electronics in synergistic co-operation. The electronic control is responsible for the dynamic behaviour and the special computing transfer block for the real time interaction and compensation of floor vibration disturbances. INTRODUCTION The method for ...
متن کاملThe Development of an Intelligent Hybrid Active-passive Vibration Isolator
A hybrid active-passive vibration isolator made up of electromagnetic actuator and air spring in parallel can be used to effectively isolate the broadband and line spectrum vibration of mechanical equipment simultaneously. However, due to its reliability and safety problems caused by the impact, its application in ships is limited. In this paper, an impactresistant structure and an air gap self...
متن کاملThe effect of beam inclination on the performance of a passive vibration isolator using buckled beams
Passive vibration isolators are desired to have both high static stiffness to support large static load and low local stiffness to reduce the displacement transmissibility at frequencies greater than resonance. Utilization of a vertical buckled beam as a spring component is one way to realize such a stiffness characteristic since it exhibits a smaller ratio of local stiffness to static stiffnes...
متن کاملOn Parameter Study of Cubic Nonlinear Vibration Isolator
The purpose of optimizing isolator parameters is to have a system that is stiff at low frequency but soft in high frequency. However, in this case a small amount of transmitted force will cause a large displacement in isolator. Exceeding the allowable relative displacement may cause serious damage to the system. Therefore a trade off between the transmitted force, which is indicated by absolute...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 2014
ISSN: 0912-0289,1882-675X
DOI: 10.2493/jjspe.80.94