Vibration Isolator Using Metal Springs for Looms
نویسندگان
چکیده
منابع مشابه
Mechatronic Vibration Isolator for the Microtechnics with Real-time Interaction
A mechatronic vibration isolation system has been developed on the basis of system theory. This equipment integrates mechanics, pneumatics and electronics in synergistic co-operation. The electronic control is responsible for the dynamic behaviour and the special computing transfer block for the real time interaction and compensation of floor vibration disturbances. INTRODUCTION The method for ...
متن کاملTaber vibration isolator for vacuum and cryogenic applications
We present a procedure for the design and construction of a passive, multipole, mechanical high-stop vibration isolator. The isolator, consisting of a stack of metal disks connected by thin wires, attenuates frequencies in the kilohertz range, and is suited to both vacuum and cryogenic environments. We derive an approximate analytical model and compare its predictions for the frequencies of the...
متن کاملVibration Reduction Module with Flexure Springs for Personal Tools
In the various working field, vibration may cause injurious to human body. Especially, in case of the vibration which is constantly and repeatedly transferred to the human. That gives serious physical problem, so called, Reynaud phenomenon. In this paper, we propose a vibration transmissibility reduction module with flexure mechanism for personal tools. At first, we select a target personal too...
متن کاملThe Development of an Intelligent Hybrid Active-passive Vibration Isolator
A hybrid active-passive vibration isolator made up of electromagnetic actuator and air spring in parallel can be used to effectively isolate the broadband and line spectrum vibration of mechanical equipment simultaneously. However, due to its reliability and safety problems caused by the impact, its application in ships is limited. In this paper, an impactresistant structure and an air gap self...
متن کاملMicrostereolithography of Three-Dimensional Polymeric Springs for Vibration Energy Harvesting
The inefficiency in converting low frequency vibration (6∼240Hz) to electrical energy remains a key issue for miniaturized vibration energy harvesting devices. To address this subject, this paper reports on the novel, three-dimensional micro-fabrication of spring elements within such devices, in order to achieve resonances and maximum energy conversion within these common frequencies. The proce...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sen'i Kikai Gakkaishi (Journal of the Textile Machinery Society of Japan)
سال: 1974
ISSN: 0371-0580,1880-1994
DOI: 10.4188/transjtmsj.27.10_p617