Visualization of Stress Distribution on Ultrasonic Vibration Aided Drilling Process
نویسندگان
چکیده
منابع مشابه
vibration drilling tool and thrust force investigation in vibratory drilling process of al 2024-t6
vibratory drilling (vd)process is a new modern technology where longitudinal wave with high frequency (more than 16 khz) and low amplitude (usually between 2 up to 30 µm) is superimposed on the movement of cutting tool, resulting in connection and disconnection of cutting tool engagement with workpiece. in this study, in order to perform vibratory drilling process, two vibration tools are desig...
متن کاملInfluence of ultrasonic vibration on micro-extrusion.
Micro-forming is a miniaturization technology with great potential for high productivity. Some technical challenges, however, need to be addressed before micro-forming becomes a commercially viable manufacturing process. These challenges include severe tribological conditions, difficulty in achieving desired tolerances, and short tool-life due to inability of available die materials to withstan...
متن کاملultrasonic assisted drilling of bone
ultrasonic assisted drilling (usd) is new technique to drill difficult to machine materials. in this method, tool or workpiece vibrates with amplitude of few microns in addition to conventional drill bite rotation. in this experimental research, the bone was drilled both conventionally and using uad, then the thrust was measured in two methods at feed rates of 50, 75 and 125 mm/s and 500, 710 a...
متن کاملModeling and Verification of Temperature Distribution and Residual Stress in Laser Aided Metal Deposition Process
Laser Metal Deposition is a novel, robust technique to manufacture or repair complex aerospace parts. However, as this process is very complicated and often operating at very high temperature, the resulting material behavior is hard to predict. The strain and stress induced by large thermal gradients in the fabrication process may cause parts failure such as cracking and distortion, so it is es...
متن کاملApplication of Taguchi Approach in the Optimization of Cutting Parameters in Micro-Ultrasonic Drilling Process
In the present research work, effect of several process parameters on the machining characteristics of borosilicate glass has been reported. The machining characteristics that are being investigated are material removal rate (MRR) and tool wear rate (TWR). Four different process parameters were considered for this study power rating of the machine, static load, slurry concentration and abrasive...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Advanced Mechanical Design, Systems, and Manufacturing
سال: 2012
ISSN: 1881-3054
DOI: 10.1299/jamdsm.6.771