Volume Deformation Characteristics of Concrete Mixture during Thermal Curing Process
نویسندگان
چکیده
منابع مشابه
Strength Characteristics of Self-curing Concrete
Today concrete is most widely used construction material due to its good compressive strength and durability. Depending upon the nature of work the cement, fine aggregate, coarse aggregate and water are mixed in specific proportions to produce plain concrete. Plain concrete needs congenial atmosphere by providing moisture for a minimum period of 28 days for good hydration and to attain desired ...
متن کاملPlastic Deformation Characteristics of Continuous Confined Strip Shearing Process Considering the Deformation Homogeneity and Damage Accumulation
In the present investigation, two dimensional elastoplastic finite element analysis was conducted to assess the deformation characteristics of Al 1100 alloy during continuous confined strip shearing (C2S2) process. The results of simulations showed that the plastic strain distribution across the deformed sample is non-uniform irrespective of the amount of friction and C2S2 die angle. The most u...
متن کاملInternal Curing with Crushed Returned Concrete Aggregates
High performance concrete (HPC) requires a low water-to-cementitious materials mass ratio (w/cm), often with the inclusion of supplemental cementitious materials such as silica fume in the mixture, thus necessitating the use of a superplasticizer. Because of the low w/cm and rapid reaction at early ages, proper curing from the earliest time possible is very essential in HPC. Internal curing has...
متن کاملMicrostructure, deformation and cracking characteristics of thermal spray ferrous coatings
The microstructure and local mechanical characteristics of thermal spray ferrous coatings have been determined. The emphasis has been on coatings made by the high velocity oxyfuel (HVOF) process, especially the role of Al alloy additives. The oxide phase present in the material and preferred pathways for local cracking and separation have been determined. Thin intersplat oxide layers emerge as ...
متن کاملOptimization of thermal curing cycle for a large epoxy model
Heat generation in an exothermic reaction during the curing process and low thermal conductivity of the epoxy resin produces high peak temperature and temperature gradients which result in internal and residual stresses, especially in large epoxy samples. In this paper, an optimization algorithm was developed and applied to predict the thermal cure cycle to minimize the temperature peak and the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC Web of Conferences
سال: 2019
ISSN: 2261-236X
DOI: 10.1051/matecconf/201925301008