Weak measurement amplification based on thermal noise effect
نویسندگان
چکیده
منابع مشابه
Charge sensing amplification via weak values measurement.
A protocol employing weak values (WVs) to obtain ultrasensitive amplification of weak signals in the context of a solid-state setup is proposed. We consider an Aharonov-Bohm interferometer where both the orbital and the spin degrees of freedom are weakly affected by the presence of an external charge to be detected. The interplay between the spin and the orbital WVs leads to a significant ampli...
متن کاملIntroduction to Quantum Noise, Measurement and Amplification
A.A. Clerk, M.H. Devoret, S.M. Girvin, Florian Marquardt, and R.J. Schoelkopf Department of Physics, McGill University, 3600 rue University Montréal, QC Canada H3A 2T8∗ Department of Applied Physics, Yale University PO Box 208284, New Haven, CT 06520-8284 Department of Physics, Yale University PO Box 208120, New Haven, CT 06520-8120 Department of Physics, Center for NanoScience, and Arnold Somm...
متن کاملThe amplification of weak measurements under quantum noise
The influence of outside quantum noises on the amplification of weak measurements is investigated. Three typical quantum noises are discussed. The maximum values of the pointer’s shifts decrease sharply with the strength of the depolarizing channel and phase damping. In order to obtain significant amplified signals, the preselection quantum systems must be kept away from the two quantum noises....
متن کاملEffect of measurement noise on Granger causality.
Most of the signals recorded in experiments are inevitably contaminated by measurement noise. Hence, it is important to understand the effect of such noise on estimating causal relations between such signals. A primary tool for estimating causality is Granger causality. Granger causality can be computed by modeling the signal using a bivariate autoregressive (AR) process. In this paper, we grea...
متن کاملMechanical squeezing via parametric amplification and weak measurement.
Nonlinear forces allow motion of a mechanical oscillator to be squeezed below the zero-point motion. Of existing methods, mechanical parametric amplification is relatively accessible, but previously thought to be limited to 3 dB of squeezing in the steady state. We consider the effect of applying continuous weak measurement and feedback to this system. If the parametric drive is optimally detun...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics B: Atomic, Molecular and Optical Physics
سال: 2020
ISSN: 0953-4075,1361-6455
DOI: 10.1088/1361-6455/ab6d91