Wear of semi-solid rheocast SiCp/Al metal matrix composites
نویسندگان
چکیده
منابع مشابه
Wear of ceramic particle-reinforced metal-matrix composites
Wear experiments have shown that when the applied normal stress exceeds a critical value, a transition occurs from the regime of mild wear to that of adhesive wear. As a result, the wear rate of particle-reinforced aluminium composites increases by a hundred-fold. Based on dislocation and delamination theories, a criterion is proposed for determining the critical transition load, and a quantita...
متن کاملBasics of Metal Matrix Composites
Metal composite materials have found application in many areas of daily life for quite some time. Often it is not realized that the application makes use of composite materials. These materials are produced in situ from the conventional production and processing of metals. Here, the Dalmatian sword with its meander structure, which results from welding two types of steel by repeated forging, ca...
متن کاملDRY SLIDING WEAR BEHAVIOUR OF STIR CAST LM 25/ZrO2 METAL MATRIX COMPOSITES
In the present study, an investigation into wear properties has been carried out to identify the influence of ZrO2 as the reinforcement material on the LM25 MMC composite. Aluminum LM25 is selected as the base material, and it is reinforced with varying proportions of 0, 3, 6, 9, 12 and 15% of zirconia (ZrO2) manufactured by stir casting. Six tensile test and wear test samples were prepared acc...
متن کاملDevelopment of in-Situ Al-Si/CuAl2 Metal Matrix Composites: Microstructure, Hardness, and Wear Behavior
In the present work, in-situ metal matrix composites were fabricated through squeeze casting. The copper particles were dispersed with different weight percentages (3%, 6%, 10%, and 15%) into Al-12% Si piston alloy. Also, heat treatments were performed at 380 °C and 450 °C for holding times of 6 and 18 h. The microstructures, X-ray diffractometer (XRD) pattern, hardness, and wear characteristic...
متن کاملBi-continuous metal matrix composites
Bi-continuous alumina/aluminium composites were made by infiltrating an alumina preform which had the structure of a reticulated ceramic foam. The low density preforms were prepared from a polyurethane suspension of alumina powder which was pyrolysed and sintered after foaming. Higher density preforms consisted of ceramic foams with open cells. All these preforms were infiltrated with 6061 alum...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of Nonferrous Metals Society of China
سال: 2010
ISSN: 1003-6326
DOI: 10.1016/s1003-6326(10)60594-8