Wear Properties of Duplex Surface Treated Alloy Tool Steel Sliding Against Aluminum Alloy.
نویسندگان
چکیده
منابع مشابه
High temperature wear and frictional properties of duplex-treated tool steel sliding against a two phase brass
Improvement of die life in the hot forging of brass alloys is considered vital from both technical and economical points of view. In this research, pin-ondisc tests were carried out at a range of temperatures to evaluate the influence of plasma nitriding and duplex nitriding-physical vapour deposition (PVD), including TiN-TiAlN and TiN-TiAlN-CrAlN coatings, on the tribological properties of AIS...
متن کاملEnhancing Wear Resistance of Squeeze Cast AC2A Aluminum Alloy
The effect of squeeze casting process parameters on wear behavior of AC2A aluminium alloy was primarily investigated in this experimental study. Five process parameters, namely squeeze pressure, pouring temperature, die temperature, die material and compression time, each at four levels were chosen and sixteen experimental runs based on L16 orthogonal array were performed. From analysis of vari...
متن کاملLow–Alloy Duplex, Directly–Quenched Transformation–Induced Plasticity Steel
A duplex microstructure consisting of allotriomorphic ferrite and austenite at ambient temperature, has been produced in a low–alloy steel, by a simple heat treatment which involves intercritical annealing followed by quenching. The tensile properties obtained are good, with a total elongation of some 28% at an ultimate tensile strength approaching 900MPa. The form of the stress versus strain c...
متن کاملEffects of Doping Elements on the Friction and Wear of SUJ2 Steel Sliding against Aluminum Alloys
Damage to mechanical components caused by wear is considered to be an important issue for mechanical engineers. For the purpose of wear resistance, it is necessary to improve the material properties of the mechanical elements. Furthermore, low friction plays an important role in saving energy. Hence, it is important to establish a key technology for wear resistance and low friction through appr...
متن کاملModeling of Tool Wear in Turning EN 31 Alloy Steel using Coated Carbide Inserts
The experimental investigations of the tool wear in turning of EN 31 alloy steel at different cutting parameters are reported in this paper. Mathematical model has been developed for flank wear using response surface methodology. This mathematical model correlates independent cutting parameters viz. cutting speed, feed rate and depth of cut with dependent parameters of flank wear. This model is...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1999
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.65.4846