WEDM cutting of Inconel 718 nickel-based superalloy: effects of cutting parameters on the cutting quality
نویسندگان
چکیده
منابع مشابه
Investigation of Cutting Forces Superalloy Inconel 718
Since the cutting tools used in machining process of super alloys are subjected to high cutting forces, accordingly tools life is reduced, therefore improvement in alloys machining and reducing cutting forces to achieve longer tools life is an essential necessity. In this research, the effect of changes in feed rate on cutting forces in machining process of nickel based super alloys is investig...
متن کاملExperimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملLASER CUTTING PARAMETERS The laser cutting parameters are dependent on the beam characteristics, the cutting rate
The laser cutting parameters are dependent on the beam characteristics, the cutting rate required, the composition and thickness of the material to be cut, and the desired cut edge quality. The laser cutting process and cut quality depend upon the proper selection of laser and workpiece parameters. Deficiencies in cutting quality may be related to the slow process drifts and disturbances that a...
متن کاملThe Effects of ZrO2 or Tic on the Performance of the Alumina-Based Ceramic Cutting Tools
Two types of alumina-based cutting tools with compositions of 90 vol.% Al2O3+10 vol.% ZrO2 and 80 vol.% A12O3+20 vol.% TiC are produced by isostatic pressing and sintering technique. The effects of these additives on the mechanical properties and cutting performance of these materials are investigated. The tool life in both materials is examined under identical conditions on cutting a grey cast...
متن کاملEffects of the Cutting Fluid Types and Cutting Parameters on Surface Roughness and Thrust Force
In this study, three different vegetable-based cutting fluids developed from raw and refined sunflower oil and two commercial types (vegetable and mineral based cutting oils), were carried out to determine for thrust force and surface roughness during drilling of AISI 304 austenitic stainless steel with HSSE tool. The uses of vegetable cutting oils was investigated in reducing thrust force and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materiali in tehnologije
سال: 2016
ISSN: 1580-2949,1580-3414
DOI: 10.17222/mit.2015.026