منابع مشابه
Measurement of local creep properties in stainless steel welds
A high temperature measurement system for creep deformation based on the digital image correlation (DIC) technique is described. The new system is applied to study the behaviour of a multi-pass welded joint in a high temperature tensile test and a load controlled creep test at 545°C. Spatially resolved tensile properties and time dependent creep deformation properties across a thick section typ...
متن کاملCorrosion performance of welds in duplex, superduplex and lean duplex stainless steels
To achieve good corrosion resistance in a weld is much more challenging than for plate or sheet material, which has undergone controlled rolling, heat treatment and pickling processes in the steel mill. The choice of weld procedure and parameters, filler metal and shielding gas all play important roles. For duplex and lean duplex grades it is essential to ensure that an adequate amount of auste...
متن کاملStudy on Static Recrystallization Process in Duplex Stainless Steel 2205
Steel 2205 is one of the most famous duplex stainless steels. The microstructure of this steel composed of ferrite and austenite in similar amount. Therefore, in order to improve mechanical properties through microstructure, thermo mechanical processes such as controlled hot rolling and forging should be applied. It is not possible to employ the usual heat treatment. It shows the importance of ...
متن کاملCrystallography of Widmanstätten austenite in duplex stainless steel weld metal
Two kinds of austenite grow from d-ferrite during the cooling of the duplex stainless steel weld deposits studied here, Widmanstätten plates and allotriomorphs which precipitate at d–d grain boundaries. It is found using microtexture measurements that the preferred crystallographic orientation of the Widmanstätten austenite can be estimated using established theory if it is assumed that there i...
متن کاملKinetics of Sigma Phase Formation In a Duplex Stainless Steel
This work determines the kinetics of sigma phase formation in UNS S31803 Duplex Stainless Steel (DSS), describing the phase transformations that occur in isothermal aging between 700 and 900 °C for time periods up to 1032 hours, allowing the determination of the Time-Temperature-Precipitation (TTP) diagram for sigma phase and proposing a model to predict the kinetics of sigma phase formation us...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ANNALS OF THE ORADEA UNIVERSITY. Fascicle of Management and Technological Engineering.
سال: 2010
ISSN: 1583-0691
DOI: 10.15660/auofmte.2010-1.1781