Wideband bandpass‐to‐all‐stop reconfigurable filtering power divider with bandwidth control and all‐passband isolation
نویسندگان
چکیده
منابع مشابه
A compact ultra-wideband power divider with favorable selectivity using transversal filtering transformer
A compact ultra-wideband (UWB) power divider with favorable selectivity is proposed. A transversal filtering transformer consisting of two different centrally loaded resonators with common feeding lines is introduced at input port to obtain good in-band response and high out-of-band rejection. Simple and rapid design procedure is adopted to find the key parameters. A prototype power divider is ...
متن کاملUltra Wideband Power Divider Using Tapered Line
A power divider with ultra-wideband (UWB) performance has been designed. The quarter-wave transformer in the conventional Wilkinson power divider is replaced by an exponentially tapered microstrip line. Since the tapered line provides a consistent impedance transformation across all frequencies, very low amplitude ripple of 0.2 dB peak-to-peak in the transmission coefficient and superior input ...
متن کاملA 28-36 GHz Optimized CMOS Distributed Doherty Power Amplifier with A New Wideband Power Divider Structure
Background and Objectives: In this paper, a new design strategy was proposed in order to enhance bandwidth and efficiency of power amplifier. Methods: To realize the introduced design strategy, a power amplifier was designed using TSMC CMOS 0.18um technology for operating in the Ka band, i.e. the frequency range of 26.5-40GHz. To design the power amplifier, first a power divider (PD) with a ver...
متن کاملIsolation Enhanced Multiway Power Divider for Wideband (3:1) Beamforming Array
In this paper, an isolation enhanced multiway power divider for wideband beamforming array is proposed. This method is based on the concept which converts the divider into multi-section stepped impedance transformer. In addition to this scheme, lumped inductors and capacitors are incorporated in isolation networks to enhance the isolation bandwidth of the divider. In/Output reflection and isola...
متن کاملIsolation Enhanced Multiway Power Divider for Wideband (4: 1) Beamforming Arrays
This paper proposes a multiway power divider for wideband (4:1) beamforming arrays. The divider’s input reflection characteristic (S11) is achieved using a multisection stepped-impedance transformer. Moreover, the divider’s isolation (S32) bandwidth is increased by incorporating inductors and capacitors in addition to the conventional resistor only isolation networks of the divider. The analysi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IET Microwaves, Antennas & Propagation
سال: 2018
ISSN: 1751-8733,1751-8733
DOI: 10.1049/iet-map.2017.0714