Wind Tunnel Tests of Wind-Induced Snow Distribution for Cubes with Holes
نویسندگان
چکیده
منابع مشابه
Wind Tunnel Tests for Wind Pressure Distribution on Gable Roof Buildings
Gable roof buildings are widely used in industrial buildings. Based on wind tunnel tests with rigid models, wind pressure distributions on gable roof buildings with different aspect ratios were measured simultaneously. Some characteristics of the measured wind pressure field on the surfaces of the models were analyzed, including mean wind pressure, fluctuating wind pressure, peak negative wind ...
متن کاملWind tunnel tests of a free yawing downwind wind turbine
This research paper presents preliminary results on a behavioural study of a free yawing downwind wind turbine. A series of wind tunnel tests was performed at the TU Delft Open Jet Facility with a three bladed downwind wind turbine and a rotor radius of 0.8 meters. The setup includes an off the shelf three bladed hub, nacelle and generator on which relatively flexible blades are mounted. The to...
متن کاملWind Tunnel Experiments: Influence of Erosion and Deposition on Wind-Packing of New Snow
Wind sometimes creates a hard, wind-packed layer at the surface of a snowpack. The formation of such wind crusts was observed during wind tunnel experiments with combined SnowMicroPen and Microsoft Kinect sensors. The former provides the hardness of new and wind-packed snow and the latter spatial snow depth data in the test section. Previous experiments had shown that saltation is necessary but...
متن کاملCFD for Better Understanding of Wind Tunnel Tests
CFD requires validation for complicated flow problems involving complex physics such as turbulence. Wind tunnels are still the most commonly used validation tools for CFD including physical modelling although some limited use of reliable DNS data base for simple geometries is recently becoming possible. One can observe the trend that a higher and higher demand on the accuracy of the wind tunnel...
متن کاملClosed-Loop Control Wind Tunnel Tests on an Adaptive Wind Turbine Blade for Load Reduction
Wind tunnel tests on a non-rotating, dynamically scaled wind turbine blade equipped with variable trailing edge geometry were carried out. The effectiveness of the system for active load reduction purposes, with the interaction between structural dynamics, aerodynamics and control was tested. The actuation of the adaptive trailing edge was based on a piezoelectric bender actuator. The full aero...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Civil Engineering
سال: 2019
ISSN: 1687-8086,1687-8094
DOI: 10.1155/2019/4153481