X-Ray Investigations on M-Si-B Systems (M = Mn, Fe, Co). II. Some Features of the Fe-Si-B and Mn-Si-B Systems.
نویسندگان
چکیده
منابع مشابه
Catalytic oxidation of toluene over LaBO3 (B= Fe, Mn and Co) and LaCo0.7B′0.3O3 (B′= Fe and Mn) perovskite-type
In this paper, LaBO3 perovskite type catalyst formulations were prepared by sol-gel auto combustion method using citric acid as the fuel. Activity of catalysts was tested in catalytic oxidation of toluene as a model of volatile organic compounds. LaCoO3 perovskite formulation showed the highest activity among LaBO3 (Fe, Mn and Co) perovskite catalysts. So, LaCoO3 perovskite based catalyst was s...
متن کاملTuneable Giant Magnetocaloric Effect in (Mn,Fe)2(P,Si) Materials by Co-B and Ni-B Co-Doping
The influence of Co (Ni) and B co-doping on the structural, magnetic and magnetocaloric properties of (Mn,Fe) 2 (P,Si) compounds is investigated by X-ray diffraction (XRD), differential scanning calorimetry, magnetic and direct temperature change measurements. It is found that Co (Ni) and B co-doping is an effective approach to tune both the Curie temperature and the thermal hysteresis of (Mn,F...
متن کاملATOMIC AND MAGNETIC SRO IN Fe-Mn-Si ALLOYS
Neutron diffuse scattering and saturation magnetization experiments have been made on single crystals specimens of Fe3-,MnCSi with c = 0.164 and 0.284 at room temperature. Atomic clustering of Mn atoms on the B sublattice has been revealed. A model of magnetic moment distribution around Mn impurities has been developed and fitted to the experimental magnetic diffuse cross sections. RRsults obta...
متن کاملcatalytic oxidation of toluene over labo3 (b= fe, mn and co) and laco0.7b′0.3o3 (b′= fe and mn) perovskite-type
in this paper, labo3 perovskite type catalyst formulations were prepared by sol-gel auto combustion method using citric acid as the fuel. activity of catalysts was tested in catalytic oxidation of toluene as a model of volatile organic compounds. lacoo3 perovskite formulation showed the highest activity among labo3 (fe, mn and co) perovskite catalysts. so, lacoo3 perovskite based catalyst was s...
متن کاملTransformation Reversibility in Fe-Mn-Si Shape Memory Alloy
The change of the surface relief associated with stress-induced epsilon martensite before and after the reverse transformation in an Fe-33%Mn-6%Si alloy (Msz264K) has been investigated. The permanent strain of a 2.7% tensile-strained specimen was 1.1% after the reverse transformation. In this specimen, a large part of surface relief still remained after heating to 623K (above Af). When five tra...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Chemica Scandinavica
سال: 1960
ISSN: 0904-213X
DOI: 10.3891/acta.chem.scand.14-1403