XFEM investigation of a crack path in residual stresses resulting from quenching
نویسندگان
چکیده
منابع مشابه
Crack Interaction Studies Using XFEM Technique
In this paper, edge crack problems under mechanical loads have been analysed using extended finite element method (XFEM) as it has proved to be a competent method for handling problems with discontinuities. The XFEM provides a versatile technique to model discontinuities in the solution domain without re-meshing or conformal mesh. The stress intensity factors (SIF) have been calculated by domai...
متن کاملResidual Stresses Measurement of a Quenched Cylinder using Slitting Method
Residual Stress measurement has gained interests among researchers for many years due to its great influence on the structural integrity. Slitting method is one of the destructive techniques that relies on the introduction of an increasing cut to a part containing residual stresses. Similar to all other mechanical strain relief techniques, slitting also suffers from its shortcomings during the ...
متن کاملresidual stresses in thermoplastic composites: a review
applications of thermoplastic composites have developed extensively. the thermoplastic composites in comparison with the thermoset composites have many advantages. thermoplastic composites can be melted and remolded many times. the duration of manufacturing process of these composites is short, producing very tough material, and the welding ability and multiple recyclings are their further adva...
متن کاملPrediction of Residual Stresses for a Hollow Product in Cold Radial Forging Process
Radial forging is an open die forging process used for reducing the diameters of shafts, tubes, stepped shafts and axles and also for creating internal profiles such as rifling the gun barrels. The radial forging of tube is usually performed over a mandrel to create an internal profile and/or size the internal diameter. Most of the previous studies conducted on the radial forging process have u...
متن کاملOn the Changes of Residual Stresses Resulted from Carburizing and Quenching due to Aging and Repeated Stressing
Residual stresses resulted from carburizing and quenching were measured dy the etching method, using plate specimens of two kinds of steels. The microstructure after quenching is likely to include retained austenite due to high carbon content of the carburized layer, which may decompose into martensite in time at room temperature. To investigate the effect of aging on the distribution of residu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Finite Elements in Analysis and Design
سال: 2013
ISSN: 0168-874X
DOI: 10.1016/j.finel.2013.07.005