XRD and EBSD Measurements of Directional Solidification Fe-C Eutectic Alloy
نویسندگان
چکیده
منابع مشابه
Stability of eutectic carbide in Fe-Cr-Mo-W-V-C alloy
The stability of the eutectic carbide in a self-designed Fe-Cr-Mo-W-V-C alloy during solidifi atio as a alyzed i this ork. The ar ide pre ipitatio rule of the steel was calculated by Thermo-Calc.The typical microstructures at 1240 °C and 1200 °C ere o ser ed y opti al i ros ope OM ,field e issio s a i g ele tro microscope (FESEM) and transmission electron microscope (TEM). The selected area dif...
متن کاملDirectional solidification of metal-gas eutectic and fabrication of regular porous metals
Directional solidification of metal-gas eutectic (Gasar) is a novel process for making regular porous metals. This process is based on a solid-gas eutectic reaction involving a gaseous medium and a metal or a ceramic phase, and allows an easy control of the porosity, such as its pore size, pore orientation and morphology in a wide range by properly adjusting its melting and solidification condi...
متن کاملEutectic Solidification Limits and Mechanical Properties of Sm-Co-Fe Alloys
Creating a permanent magnet with a higher energy product than existing materials is attractive in order to optimize magnetic performance. The eutectic microstructure of Sm-Co alloys is attractive for magnets since primary rods of the Co-phase can act as a soft magnetic phase in the matrix of the Sm 2 Co 17 hard magnetic phase, forming two-phase magnets. Fe replacement in Sm-Co alloys provides a...
متن کاملEffect of Sb Addition on the Solidification of Deeply Undercooled Ag-28.1 wt. % Cu Eutectic Alloy
Ag-28.1 wt. % Cu eutectic alloy solidifies in the form of eutectic dendrite at undercooling above 76 K. The remelting and ripening of the original lamellar eutectics result in the formation of the anomalous eutectics in the final microstructure. The addition of the third element Sb (0.5 and 1 wt. %) does not change the growth mode, but enlarges the volume fraction of anomalous eutectics because...
متن کاملPhase-Field Models for Eutectic Solidification
This article discusses two methods for modeling eutectic solidifi cation using the phase-field approach. First, a multi-phase-fi eld model is used to study the three-dimensional morphological evolution of binary eutectics. Performing the calculations in three dimensions allows observation of both lamellar and rod-like structures as well as transient phenomena such as lamellar fault motion, rod-...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Archives of Foundry Engineering
سال: 2016
ISSN: 2299-2944
DOI: 10.1515/afe-2016-0104