stiffness and deformation characteristics of a cemented gravely sand

نویسندگان

amir hamidi

s. mohsen haeri

چکیده

the deformation and stiffness characteristics of a cemented gravely sand was investigated using triaxial equipment. the triaxial tests were conducted in both dry and saturated undrained conditions. artificially cemented samples are prepared using gypsum plaster as the cementing agent. the plaster was mixed with the base soil at the weight percentages of 1.5, 3, 4.5 and 6. the applied confining pressure varied between 25 to 500 kpa in triaxial tests. the process of yielding of the soil was investigated for the considered soil and the bond and final yield points were identified for the cemented soil with different cement contents. the variations of deformation and stiffness parameters with cement content and confining stress were studied as well. some of the parameters were determined for both drained and undrained conditions to investigate the effect of drainage condition on the stiffness and yield characteristics of the tested cemented gravely sand. according to the results, the difference between drained and undrained tangent stiffness decreases with increase in confining stress. finally the effect of cement type was investigated as an important parameter affecting the stiffness at bond yield. the rate of increase in tangent stiffness at bond yield changes with cement content for different cementing agents.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Impact of Fiber Reinforcement on Deformation Characteristics of Cemented Sand-Gravel Mixtures

This paper describes triaxial compression tests conducted to determine the effect of fiber inclusion on stiffness and deformation characteristics of sand-gravel mixtures. Tested soil was a mixture of Babolsar sand from the shores of the Caspian Sea and Karaj River gravel. Portland cement was used as the cementing agent and fibers 12mm in length and 0.023mm in diameter at 0%, 0.5% and 1.0% were ...

متن کامل

Deformation Characteristics of Composite Structures

The composites provide design flexibility because many of them can be moulded into complex shapes. The carbon fibre-reinforced epoxy composites exhibit excellent fatigue tolerance and high specific strength and stiffness which have led to numerous advanced applications ranging from the military and civil aircraft structures to the consumer products. However, the modelling of the beams undergoin...

متن کامل

a comparison of linguistic and pragmatic knowledge: a case of iranian learners of english

در این تحقیق دانش زبانشناسی و کاربردشناسی زبان آموزان ایرانی در سطح بالای متوسط مقایسه شد. 50 دانش آموز با سابقه آموزشی مشابه از شش آموزشگاه زبان مختلف در دو آزمون دانش زبانشناسی و آزمون دانش گفتار شناسی زبان انگلیسی شرکت کردند که سوالات هر دو تست توسط محقق تهیه شده بود. همچنین در این تحقیق کارایی کتابهای آموزشی زبان در فراهم آوردن درون داد کافی برای زبان آموزان ایرانی به عنوان هدف جانبی تحقیق ...

15 صفحه اول

effect of bataine and sulphate supplement on wool and milk characteristics and lambs performance in naine ewes

تعداد 20 رأس میش نژاد نائینی 6+-24 ماهه، با میانگین وزن 2/3-+40 کیلوگرم، همراه با 20 رأس بره های آنها در قالب طرح کاملا تصادفی اثر بتائین و مکمل سولفات بر خصوصیات شیر و پشم و عملکرد بره ها بررسی شد. میش ها بطور تصادفی در چهار تیمار قرار گرفتند. تیمارها عبارت بودند از: 1-گروه شاهد 2-بتائین (05/0 درصد ماده خشک) 3-سولفات (24/0 سولفور درصد ماده خشک 4-بتائین هرماه با سولفات. جیره غذائی طبق nrc با مح...

15 صفحه اول

Plastic Deformation Characteristics of Continuous Confined Strip Shearing Process Considering the Deformation Homogeneity and Damage Accumulation

In the present investigation, two dimensional elastoplastic finite element analysis was conducted to assess the deformation characteristics of Al 1100 alloy during continuous confined strip shearing (C2S2) process. The results of simulations showed that the plastic strain distribution across the deformed sample is non-uniform irrespective of the amount of friction and C2S2 die angle. The most u...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید


عنوان ژورنال:
international journal of civil engineering

جلد ۶، شماره ۳، صفحات ۱۵۹-۱۷۳

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023