optimizing electrocoagulation and electro-fenton process for treating car wash waste water

background: car wash waste water contains several contaminants such as organic matter, oil, grease, detergents and phosphates, all of which are harmful for the environment. in this study, the application of electrocoagulation (ec) to treat car wash waste water has been studied, and the operating parameters optimized. the electro-fenton (ef) for further contaminant removal was also investigated. methods: in ec process, the effect of ph, current density, and the reaction time of the removal efficiency of chemical oxygen demand (cod), phosphate, and turbidity were investigated using the response surface methodology (rsm). the electrochemical cell consisted of four iron electrodes that were connected to a power supply using a monopolar arrangement. in the ef process, the effect of ph, reaction time, and hydrogen peroxide concentration on cod removal efficiency were probed. results: the optimum ph, current density, and the reaction time for the ec process were 7.3, 4.2 ma cm-2 and 20.3 minutes, respectively. under these conditions, the cod, phosphate, and turbidity removal percentages were 80.8%, 94.9% and 85.5%, respectively, and the specific energy consumption was 1.5 kwh m-3. for the ef process, the optimum ph, reaction time, current and hydrogen peroxide dosage were 3, 10 minutes, 2 a and 500 mg l-1, respectively. the ef showed higher cod removal efficiency (85.6%) with a lower specific energy consumption (0.5 kwh m-3) and reaction time compared to the ec. conclusion: this study shows that both ec and ef can effectively treat car wash waste water with high removal efficiency within a short reaction time.