multi-objective optimization of tio2-water nanofluid flow in tubes fitted with multiple twisted tape inserts in different arrangement

Multi-Objective Optimization of Tio2-Water Nanofluid Flow in Tubes Fitted With Multiple Twisted Tape Inserts in Different Arrangement

In this paper, experimentally derived correlations of heat transfer and pressure drop are used in a Pareto based Multi-Objective Optimization (MOO) approach to find the best possible combinations of heat transfer and pressure drop of TiO2-water nanofluid flow in tubes fitted with multiple twisted tape inserts in different arrangement. In this study there are four independent design variables: t...

Enhancements Of Heat Transfer Nanofluid Flow In Circular Pipe With Twisted Tape Inserts: Review

Heat transfer improvement in circular pipe by using nanofluid and twisted tape is presented in this review paper. Experimental and numerical studies are incorporated involving both the range of turbulent and laminar flow. Effect of type and volume fraction of nanofluid on performance of heat transfer was referred along with the length and twist ratio of the tape through the pipe on heat transfe...

Heat Transfer Enhancement of Laminar Nanofluids Flow in a Circular Tube Fitted with Parabolic-Cut Twisted Tape Inserts

Numerical investigation has been carried out on heat transfer and friction factor characteristics of copper-water nanofluid flow in a constant heat-fluxed tube with the existence of new configuration of vortex generator using Computational Fluid Dynamics (CFD) simulation. Two types of swirl flow generator: Classical twisted tape (CTT) and Parabolic-cut twisted tape (PCT) with a different twist ...

Multi-objective optimization of nanofluid flow in microchannel heat sinks with triangular ribs using CFD and genetic algorithms

Abstract In this paper, multi-objective optimization (MOO) of Al2O3-water nanofluid flow in microchannel heat sinks (MCHS) with triangular ribs is performed using Computational Fluid Dynamics (CFD) techniques and Non-dominated Sorting Genetic Algorithms (NSGA II). At first, nanofluid flow is solved numerically in various MCHS with triangular ribs using CFD techniques. Finally, the CFD data will...

Numerical Investigation of Heat Transfer and Friction Factor Characteristics in a Circular Tube Fitted with V-Cut Twisted Tape Inserts

Numerical investigation of the heat transfer and friction factor characteristics of a circular fitted with V-cut twisted tape (VCT) insert with twist ratio (y = 2.93) and different cut depths (w = 0.5, 1, and 1.5 cm) were studied for laminar flow using CFD package (FLUENT-6.3.26). The data obtained from plain tube were verified with the literature correlation to ensure the validation of simulat...

Convective Heat Transfer Enhancement of CNT-Water Nanofluids in Plain Tube Fitted with Wire Coil Inserts