Influence of post-hydrogenation upon electrical, optical and structural properties of hydrogen-less sputter-deposited amorphous silicon

نویسندگان

  • S. Gerke
  • H.-W. Becker
  • D. Rogalla
  • F. Singer
  • N. Brinkmann
  • S. Fritz
  • A. Hammud
  • P. Keller
  • D. Skorka
  • D. Sommer
  • C. Weiß
  • S. Flege
  • G. Hahn
  • B. Terheiden
چکیده

Amorphous silicon (a Si) is common in the production of technical devices and can be deposited by several techniques. In this study intrinsic and doped, hydrogen less amorphous silicon films are RF magnetron sputter deposited and post hydrogenated in a remote hydrogen plasma reactor at a temperature of 370 °C. Secondary ion mass spectrometry of a boron doped (p) a Si layer shows that the concentration of dopants in the sputtered layer becomes the same as present in the sputter target. Improved surface passivation of phosphorous doped 5Ω cm, FZ, (n) c Si can be achieved by post hydrogenation yielding aminority carrier lifetime of ~360 μs finding an optimum for ~40 nm thin films, deposited at 325 °C. This relatively low minority carrier lifetime indicates high disorder of the hydrogen less sputter deposited amorphous network. Post hydrogenation leads to a decrease of the number of localized states within the band gap. Optical band gaps (Taucs gab as well as E04) can be determined to ~1.88 eV after post hydrogenation. High resolution transmission electron microscopy and optical Raman investigations show that the sputtered layers are amorphous and stay like this during post hydrogenation. As a consequence of the missing hydrogen during deposition, sputtered a Si forms a rough surface compared to CVD a Si. Atomic force microscopy points out that the roughness decreases by up to 25% during post hydrogenation. Nuclear resonant reaction analysis permits the investigation of hydrogen depth profiles and allows determining the diffusion coefficients of several post hydrogenated samples from of a model developed within this work. A dependency of diffusion coefficients on the duration of post hydrogenation indicates trapping diffusion as the main diffusion mechanism. Additional Fourier transform infrared spectroscopy measurements show that hardly any interstitial hydrogen exists in the post hydrogenated a Si layers. The results of this study open the way for further hydrogen diffusion experiments which require an initially unhydrogenated drain layer.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Physical Properties of Reactively Sputter-Deposited C-N Thin Films

This work aims to prepare and study amorphous carbon nitride (CNx) films. Films were deposited by reactive magnetron radiofrequency (RF) sputtering from graphite target in argon and nitrogen mixture discharge at room temperature. The ratio of the gas flow rate was varied from 0.1 to 1. Deposited films were found to be amorphous. Highest Nitrogen concentration achieved was 42 atomic percent whic...

متن کامل

Bias-plasma assisted RF magnetron sputter deposition of hydrogen-less amorphous silicon

The execution of special hydrogen diffusion experiments requires an initially hydrogen-free drain layer. Hydrogen-free amorphous silicon (a-Si) deposited by radio frequency magnetron sputter deposition (RFSD) serves this purpose. RFSD yields a rough surface of the film but this can be flattened by an additional post-hydrogenation step. Weak Si-Si bonds are reorganized by hydrogen and the surfac...

متن کامل

A Study of ZnO Buffer Layer Effect on Physical Properties of ITO Thin Films Deposited on Different Substrates

The improvement of the physical properties of Indium Tin Oxide (ITO) layers is quite advantageous in photovoltaic applications. In this study the ITO film is deposited by RF sputtering onto p-type crystalline silicon (c-Si) with (100) orientation, multicrystalline silicon (mc-Si), and glass substrates coated with ZnO and annealed in vacuum furnace at 400°C. Electrical, optical, structural a...

متن کامل

Structural, Electrical and Optical Properties of Molybdenum Oxide Thin Films Prepared by Post-annealing of Mo Thin Films

Molybdenum thin films with 50 and 150 nm thicknesses were deposited on silicon substrates, using DC magnetron sputtering system, then post-annealed at different temperatures (200, 325, 450, 575 and 700°C) with flow oxygen at 200 sccm (standard Cubic centimeter per minute). The crystallographic structure of the films was obtained by means of x-ray diffraction (XRD) analysis. An atomic force micr...

متن کامل

Structural, Electrical and Optical Properties of Molybdenum Oxide Thin Films Prepared by Post-annealing of Mo Thin Films

Molybdenum thin films with 50 and 150 nm thicknesses were deposited on silicon substrates, using DC magnetron sputtering system, then post-annealed at different temperatures (200, 325, 450, 575 and 700°C) with flow oxygen at 200 sccm (standard Cubic centimeter per minute). The crystallographic structure of the films was obtained by means of x-ray diffraction (XRD) analysis. An atomic force micr...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2016