Finesse and mirror speed measurement for a suspended Fabry-Perot cavity using the ringing effect
نویسندگان
چکیده
We here present an investigation of the ringing effect observed on the VIRGO mode-cleaner prototype MC30. The results of a numerical calculation show how a simple empirical formula can determine the cavity expansion rate from the oscillatory behavior. We also show how the simulation output can be adjusted to estimate the finesse value of the suspended cavity.
منابع مشابه
Doppler-induced dynamics of fields in fabry-perot cavities with suspended mirrors.
The Doppler effect in Fabry-Perot cavities with suspended mirrors is analyzed. The Doppler shift, which is intrinsically small, accumulates in the cavity and becomes comparable with or greater than the linewidth of the cavity if the cavity's finesse is high or its length is large. As a result, damped oscillations of the cavity field occur when one of the mirrors passes a resonance position. A f...
متن کاملA study for reduction of radiation pressure noise in gravitational wave detectors
We describe an experimental conceptual design for observation and reduction of radiation pressure noise. The radiation pressure noise is increased in a high finesse cavity with a small mass mirror. In our experiment a Fabry-Perot Michelson interferometer with a homodyne detection scheme will be built with Fabry-Perot cavities of finesse of 10000 containing suspended mirrors of 23mg. To observe ...
متن کاملChaotically spiking attractors in suspended-mirror optical cavities.
A high-finesse suspended-mirror Fabry-Perot cavity is experimentally studied in a regime where radiation pressure and photothermal effect are both relevant. The competition between these phenomena, operating at different timescales, produces unobserved dynamical scenarios where an initial Hopf instability is followed by the birth of small-amplitude chaotic attractors that erratically but determ...
متن کاملStable, mode-matched, medium-finesse optical cavity incorporating a microcantilever mirror: optical characterization and laser cooling.
A stable optical resonator has been built using a 30-microm-wide, metal-coated microcantilever as one mirror. The second mirror was a 12.7-mm-diameter concave dielectric mirror. By positioning the two mirrors 75 mm apart in a near-hemispherical configuration, a Fabry-Perot cavity with a finesse equal to 55 was achieved. The finesse was limited by the optical loss in the cantilever's metal coati...
متن کاملWaveguide grating mirror in a fully suspended 10 meter Fabry-Perot cavity.
We report on the first demonstration of a fully suspended 10 m Fabry-Perot cavity incorporating a waveguide grating as the coupling mirror. The cavity was kept on resonance by reading out the length fluctuations via the Pound-Drever-Hall method and employing feedback to the laser frequency. From the achieved finesse of 790 the grating reflectivity was determined to exceed 99.2% at the laser wav...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2000