Voltage Mode-to-Current Mode Transformation
نویسندگان
چکیده
Abstract— This paper proposes a procedure for converting a class of Op Amp-, FTFN-, CCand CFAbased voltage mode circuits to corresponding current mode circuits without requiring any additional circuit elements and finally from Op Amp-based voltage mode circuits to any of the FTFN, CC and CFA current mode circuits. The latter circuits perform better at high frequency than the former ones. The validity of the transformation has been checked on simulated circuits with PSPICE. Keywards— Voltage mode, Current mode, Transformation, Current feedback amplifier, Current conveyor, Four terminal floating nullor
منابع مشابه
Sliding-Mode-based Improved Direct Active and Reactive Power Control of Doubly Fed Induction Generator under Unbalanced Grid Voltage Condition
This paper proposes an improved direct active and reactive power control (DPC) strategy for a grid-connected doubly fed induction generator (DFIG) based wind-turbine system under unbalanced grid voltage condition. The method produces required rotor voltage references based on the sliding mode control (SMC) approach in stationary reference frame, without the requirement of synchronous coordinate...
متن کاملAnalysis of Vector Estimating Modulation Method to Eliminate Common Mode Voltage
Abstract The problem of common mode voltage in inverters can be considered as a major issue which leads to motor bearing failures. To eliminate these voltages, proposing some methods seems to be necessary. This paper has a comparative study on estimating modulation methods of eliminating common mode voltage. The main idea of these methods is based on generation of reference vector with nearest ...
متن کاملVoltage Regulation of a Negative Output Luo Converter Using a PD-PI Type Sliding Mode Current Controller
This paper describes a new design for direct sliding mode method with a high switching frequency using the PD-PI type sliding surface applied to a negative output Luo converter worked in continuous current mode for applications required constant power source such as aerospace applications, medical equipment and etc. Because of the output power and line changes, the converter model is also nonli...
متن کاملFully Differential Current Buffers Based on a Novel Common Mode Separation Technique
In this paper a novel common mode separation technique for implementing fully differential current buffers is introduced. Using the proposed method two high CMRR (Common Mode Rejection Ratio) and high PSRR (Power Supply Rejection Ratio) fully differential current buffers in BIPOLAR and CMOS technologies are implemented. Simulation results by HSPICE using 0.18μm TSMC process for CMOS based st...
متن کاملSpace Vector Pulse Width Modulation with Reduced Common Mode Voltage and Current Losses for Six-Phase Induction Motor Drive with Three-Level Inverter
Common-mode voltage (CMV) generated by the inverter causes motor bearing failures in multiphase drives.On the other hand, presence of undesired z-component currents in six-phase induction machine (SPIM) leads to extra current losses and have to be considered in pulse width modulation (PWM) techniques. In this paper, it is shown that the presence of z-component currents and CMV in six phase driv...
متن کاملA New Trans-admittance-Mode Biquad Filter Suitable for Low Voltage Operation
The trans-admittance-mode (TAM) might act as a transforming bridge for voltage-mode to current-mode conversion. In this study a new low voltage operated electronically tunable TAM biquad filter structure realizing all the seven standard filtering functions namely; low-pass (LP), band-pass (BP), high-pass (HP), regular-notch (RN), low-pass-notch (LPN), high-pass-notch (HPN) and all-pass (AP) fro...
متن کامل