Logic emulation with virtual wires

Logic emulation enables designers to functionally verify complex integrated circuits prior to chip fabrication. However, traditional FPGA-based logic emulators have poor inter-chip communication bandwidth, commonly limiting gate utilization to less than 20 percent. Global routing contention mandates the use of expensive crossbar and PC-board technology in a system of otherwise low-cost, commodity parts. Even with crossbar technology,current emulators only use a fraction of potential communication bandwidth because they dedicate each FPGA pin (physical wire) to a single emulated signal (logical wire). Virtual Wires overcome pin limitations by intelligently multiplexing each physical wire among multiple logical wires and pipelining these connections at the maximum clocking frequency of the FPGA. The resulting increase in bandwidth allows effective use of low dimension, direct interconnect. The size of the FPGA array can be decreased as well, resulting in low cost logic emulation. This paper covers major contributions of the MIT Virtual Wires project. In the context of a complete emulation system, we analyze phase-based static scheduling and routing algorithms, present Virtual Wires synthesis methodologies, and overview an operational prototype with 20Kgate boards. Results, including in-circuit emulation of a SPARC microprocessor, indicate that Virtual Wires eliminate the need for expensive crossbar technology while increasing FPGA utilization beyond 45 percent. Theoretical analysis predicts that Virtual Wires emulation scales with FPGA size and average routing distance, while traditional emulation does not.