Introduction to RF Simulation and its Application
نویسنده
چکیده
Radio-frequency (RF) circuits exhibit several distinguishing characteristics that make them difficult to simulate using traditional SPICE transient analysis. The various extensions to the harmonic balance and shooting method simulation algorithms are able to exploit these characteristics to provide rapid and accurate simulation for these circuits. This paper is an introduction to RF simulation methods and how they are applied to make common RF measurements. It describes the unique characteristics of RF circuits, the methods developed to simulate these circuits, and the application of these methods.
منابع مشابه
Design and simulation of a RF MEMS shunt capacitive switch with low actuation voltage, low loss and high isolation
According to contact type, RF MEMS switches are generally classified into two categories: Capacitive switches and Metal-to-Metal ones. The capacitive switches are capable to tolerate a higher frequency range and more power than M-to-M switches. This paper presents a cantilever shunt capacitive RF MEMS switch with characteristics such as low trigger voltage, high capacitive ratio, short switchin...
متن کاملThe Viability of Oil Extraction from Trinidad Tar Sands by Radio Frequency Heating: A Simulation Approach
Trinidad has tar sand resources of about 2 billion barrels of oil on land in the Parrylands/Guapo and Brighton areas. With an oil price of over USD 25 per barrel, the commercial extraction of oil from Trinidad tar sands is viable, but it requires a careful study. The relatively small extent of this tar sand (about 10,000 acres and with depths varying from surface to less than 500 feet) and with...
متن کاملA Novel Assisted History Matching Workflow and its Application in a Full Field Reservoir Simulation Model
The significant increase in using reservoir simulation models poses significant challenges in the design and calibration of models. Moreover, conventional model calibration, history matching, is usually performed using a trial and error process of adjusting model parameters until a satisfactory match is obtained. In addition, history matching is an inverse problem, and hence it may have non-uni...
متن کاملDesign and Simulation of a Clamped-Clamped Micromechanical Beam AM Frequency Mixer-Filter
In the last decade Micromechanical components for communication applications has been fabricated via IC-compatible MEMS technologies. In fact, its most important impact is not at the component level, but rather at the system level, by offering alternative transceiver architectures that reduce power consumption and enhance performance. In this paper a mixer-filter for AM frequency receiver with ...
متن کاملOutput-Conductance Transition-Free Method for Improving Radio-Frequency Linearity of SOI MOSFET Circuits
In this article, a novel concept is introduced to improve the radio frequency (RF) linearity of partially-depleted (PD) silicon-on-insulator (SOI) MOSFET circuits. The transition due to the non-zero body resistance (RBody) in output conductance of PD SOI devices leads to linearity degradation. A relation for RBody is defined to eliminate the transition and a method to obtain transition-free c...
متن کامل