Synthesis and characterization of oxygen doped ZnTe for powder phosphor application

نویسنده

  • V. Valdna
چکیده

The synthesis of efficient ZnTe powder phosphors is very difficult due to its high moisture sensitivity and chemical instability during processing. In this study, an efficient ZnTe:O powder phosphor for x-ray imaging application was successfully synthesized by vacuum firing ZnTe powder prepared from ZnTe bulk crystals ball-milled in an O2 atmosphere. The phosphors were characterized by x-ray diffraction, x-ray photoelectron spectroscopy, photoluminescence, and cathodoluminescence (CL) measurements and found to exhibit a luminescent efficiency three times that of ZnTe:O prepared by ZnO doping. The ZnTe:O samples exhibited a deep red emission centered at 680 nm and a CL decay time of 1.1 s.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Synthesis and characterization of Gd2O2 S: Tb3+ phosphor powder for X-ray imaging detectors

Gadolinium oxysulfide phosphor doped with trivalent terbium have been synthesized using urea homogenous precipitation and followed by sulfurization at 800 °C under argon atmosphere. Structural and morphological of synthesized phosphor powder were characterized by x-ray diffraction (XRD), scanning electron microscopy (SEM) and Fourier transform infrared spectrometry (FT-IR). Hexagonal structure ...

متن کامل

Lu3+/Yb3+ and Lu3+/Er3+ Co-doped Antimony Selenide Nanomaterials: Synthesis, Characterization, Electrical, Thermoelectrical and Optical Properties

Lu3+/Yb3+ and Lu3+/Er3+ Co-doped Sb2Se3 nanomaterials were synthesized by a Co-reduction method in hydrothermal condition. Powder XRD patterns indicate that the LnxLn′xSb2-2xSe3 Ln: Lu3+/Yb3+ and Lu3+/Er3+ crystals (x= 0.00-0.04) are isostructural with Sb2Se3. The cell parameters were increased for compounds upon increasing the dopant content (x). SEM and TEM images show that Co-doping of Lu3+/...

متن کامل

Mechanochemical Synthesis and Characterization of N-doped TiO2 for Photocatalytic Degradation of Caffeine

The present study reports the synthesis of N-doped TiO2 photocatalyst for the degradation of caffeine using mechanochemical grinding method from the mixture of titania/urea followed by calcination at 400 ⁰C. The phase composition, particle size, surface area, morphology and optical properties...

متن کامل

Lu3+/Yb3+ and Lu3+/Er3+ Co-doped Antimony Selenide Nanomaterials: Synthesis, Characterization, Electrical, Thermoelectrical and Optical Properties

Lu3+/Yb3+ and Lu3+/Er3+ Co-doped Sb2Se3 nanomaterials were synthesized by a Co-reduction method in hydrothermal condition. Powder XRD patterns indicate that the LnxLn′xSb2-2xSe3 Ln: Lu3+/Yb3+ and Lu3+/Er3+ crystals (x= 0.00-0.04) are isostructural with Sb2Se3. The cell parameters were increased for compounds upon increasing the dopant content (x). SEM and TEM images show that Co-doping of Lu3+/...

متن کامل

Preparation and Characterization of Chromium(III)-Activated Yttrium Aluminum Borate: A New Thermographic Phosphor for Optical Sensing and Imaging at Ambient Temperatures

A new thermographic phosphor based on chromium(III)-doped yttrium aluminum borate (YAB) is obtained as single crystals by high temperature flux growth and as a microcrystalline powder via solution combustion synthesis. The phosphor is excitable both in the blue (lambda(max) 422 nm) and in the red part of the spectrum (lambda(max) 600 nm) and shows bright NIR emission. The brightness of the phos...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2005