FITS - A Fault Injection Architecture for Time-Triggered Systems
نویسنده
چکیده
Time-triggered systems require a very high degree of temporal accuracy at critical stages during run time. While many software fault injection environments exist today, none of these make provisions to meet the timing requirements of such sys-
منابع مشابه
Modeling Time-Triggered Architecture Based Real-Time Systems Using SystemC
This paper proposes a SystemC based extension for the modeling of TimeTriggered Architecture (TTA) based real-time embedded systems. The extension called Executable Time-Triggered Model (E-TTM) supports the time-triggered model of computation and provides a time domain deterministic modeling framework based on SystemC. E-TTM can be used from the architectural design phase to support early funct...
متن کاملDistributed Embedded Safety Critical Real-Time Systems, Design and Verification Aspects on the Example of the Time Triggered Architecture
The Time Triggered Architecture (TTA) and its related communication protocol, TTP/C is an emerging communication principle for distributed fault-tolerant real-time systems. Typical applications are safety-critical digital control systems such as drive-by-wire and fly-by-wire. This paper highlights the hardware / software architecture and design of the first industrial single chip communication ...
متن کاملDependability assessment of by-wire control systems using fault injection
This paper is focused on the validation by means of physical fault injection at pin level of a time-triggered communication controller: the TTP/C versions C1 and C2. The controller is a commercial off-the-shelf product used in the design of by-wire systems. Drive-by-wire and flyby-wire active safety controls aim to prevent accidents. They are considered to be of critical importance because a se...
متن کاملSimulation Tool for Functional Verification of Ttp/c–based Systems
This article describes a software tool that implements Clanguage written simulation model of distributed embedded computer system that is interconnected by means of TTP/C protocol. The aim of simulation is to evaluate specified system’s properties when used as a safety critical control system. The method that uses simulated faults to disturb system’s activity was developed during the solution o...
متن کاملEvaluation of Fault Handling of the Time-Triggered Architecture with Bus and Star Topology
Arbitrary faults of a single node in a time-triggered architecture (TTA) bus topology system may cause error propagation to correct nodes and may lead to inconsistent system states. This has been observed in validation work using software implemented fault injection (SWIFI) and heavy-ion fault injection techniques in a TTA cluster. In a TTA system, the membership and the clique avoidance algori...
متن کامل