The noise amplification index for optimal pose selection in robot calibration
نویسندگان
چکیده
This paper presents a new observability index to quantify the selection of best pose set in robot calibration. This noise amplification index is considerably more sensitive to calibration error than previously published observability indices. Support for the proposed andex is provided analytically and geometrically, and also through comparison against previous indices by a simulation for a 3-link planar robot and by an experiment for a 3-DOF redundant parallel-drive robot.
منابع مشابه
Kinematic calibration using a plane constraint
This work deals with closed-loop calibration methods where the robot endpoint is constrained to lie on a plane. Previously published calibration approaches are shown to have certain weaknesses. A new solution is given using DH and Hayati notations and standard nonlinear least squares optimization. The procedure is extended via the Implicit Loop Method, which takes input noise into account. Pose...
متن کاملOptimal pose selection for vision-based kinematic calibration of parallel mechanisms
In this paper, a new pose selection criterion for the kinematic calibration of parallel mechanisms is proposed. It enables one to take into account the measurement noise amplification that may occur for parallel mechanisms, as well as the variation of amplitude and anisotropy of the measuring device accuracy. This new criterion is applied to vision-based calibration of an Orthoglide mechanism, ...
متن کاملThe Calibration Index and Taxonomy for Robot Kinematic Calibration Methods
The major approaches toward kinematic calibration are unified by considering an end-point measurement system as forming a joint and closing the kinematic loop. A calibration index is introduced, based on the mobility equation, that considers sensed and unsensed joints and single and multiple loops and expresses the surplus of measurements over degrees of freedom at each pose. Past work using op...
متن کاملOptimal Measurement Configurations for Gough Platform Calibration
The robustness of robot calibration with respect to sensor noise is sensitive to the manipulator poses used to collect measurement data. The present paper proposes an algorithm based on a constrained optimization method which allows one to choose an set of measurement configurations. It works by selecting iteratively one pose after another inside the workspace, and after a few steps a set of N ...
متن کاملGeometric calibration of industrial robots using enhanced partial pose measurements and design of experiments
The paper deals with geometric calibration of industrial robots and focuses on reduction of the measurement noise impact by means of proper selection of the manipulator configurations in calibration experiments. Particular attention is paid to the enhancement of measurement and optimization techniques employed in geometric parameter identification. The developed method implements a complete and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1996