Part I. The Microstructural Evolution in Ti-Al-Nb O 1 Bcc Orthorhombic Alloys
نویسندگان
چکیده
Phase transformations and the resulting microstructural evolution of near-Ti2AlNb and Ti-12Al38Nb O 1 bcc orthorhombic alloys were investigated. For the near-Ti2AlNb alloys, the processing temperatures were below the bcc transus, while, for Ti-12Al-38Nb, the processing temperature was supertransus. Phase evolution studies showed that these alloys contain several constituent phases, namely, bcc, O, and a2; when present, the latter was in small quantities compared to the other phases. The transmission electron microscopy (TEM), scanning electron microscopy (SEM), and Xray investigations of samples that were solutionized and water quenched were used to estimate the phase fields, and a pseudobinary diagram based on Ti 5 50 at. pct was modified. The agingtransformation behavior was studied in detail. For solutionizing temperatures between 875 8C and the bcc transus, the phase composition and volume fraction of the near-Ti2AlNb alloys adjusted through relative size changes of the equiaxed B2, O, and a2 grains. The aging behavior followed three distinct transformation modes, dependent on the solutionizing and aging temperatures. Widmanstätten formation was observed when a new phase evolved from a parent phase. Thus, Widmanstätten O phase precipitated within the B2 phase for supertransus fully B2 microstructures, as well as for subtransus a2 1 B2 microstructures. Similarly, Widmanstätten B2 phase can form from a fully O microstructure, a transformation that has not been observed before. In the case of equiaxed O 1 B2 solutionized and water-quenched microstructures, Widmanstatten O-phase formation occurred only below 875 8C. For the subtransus-solutionized and water-quenched microstructures, a second aging transformation mode, cellular precipitation, was dominant below 750 8C. This involved formation of coarse and lenticular O phase that grew into the prior B2 grains from the grain boundaries. A third transformation mode involved composition-invariant transformation, where the fully B2 supertransussolutionized and water-quenched microstructure transformed to a fully O microstructure at 650 8C. This microstructure reprecipitated B2 phase out of the O phase with continued aging time. For Ti12Al-38Nb, Widmanstätten O precipitation remained the only transformation mode. It is shown that subtransus processing offers flexibility in controlling microstructures through postprocessing heat treatments.
منابع مشابه
Transformation of BCC and B2 High Temperature Phases to HCP and Orthorhombic Structures in the Ti-Al-Nb System. Part II: Experimental TEM Study of Microstructures
Possible transformation paths that involve no long range diffusion and their corresponding microstructural details were predicted by Bendersky, Roytburd, and Boettinger [J. Res. Natl. Inst. Stand. Technol. 98, 561 (1993)] for Ti-Al-Nb alloys cooled from the high temperature BCC/B2 phase field into close-packed orthorhombic or hexagonal phase fields. These predictions were based on structural an...
متن کاملTransformation of BCC and B2 High Temperature Phases to HCP and Orthorhombic Structures in the Ti-Al-Nb System. Part I: Microstructural Predictions Based on a Subgroup Relation Between Phases
Possible paths for the constant composition coherent transformation of BCC or B2 high temperature phases to low temperature HCP or Orthorhombic phases in the Ti-Al-Nb system are analyzed using a sequence of ciystallographic structural relationships developed from subgroup symmetry relations. Symmetry elements lost in each step of the sequence determine the possibilities for variants of the low ...
متن کاملThe Microstructure, Creep, and Tensile Behavior for Ti-5Al-45Nb (Atomic Percent) Fully-b Alloy
The microstructure, tensile, and creep behavior of a Ti-5Al-45Nb (at. pct) alloy was evaluated. The main objective of processing and characterizing this alloy was to obtain the constituent properties of a fully-b Ti-Al-Nb alloy to aid in modeling the tensile and creep properties of twophase orthorhombic + body-centered-cubic (O + bcc) alloys. A second objective was to compare the tensile and cr...
متن کاملMicrostructure-Property Relationships of Two Ti2AlNb-based Intermetallic Alloys: Ti-15Al-33Nb(at.%) and Ti-21Al-29Nb(at.%)
Two Ti2AlNb intermetallic orthorhombic (O) alloys, Ti-15Al-33Nb and Ti-21Al29Nb(at.%), were subtransus processed into sheets, using pancake forging and hot-pack rolling, and evaluated in tension (25 and 650°C) and creep (650-710°C) and the properties and deformation behavior were related to microstructure. Some of the microstructural features evaluated were grain boundary character, grain size,...
متن کاملCritical stress for the bcc–hcp martensite nucleation in Ti–6.25at.%Ta and Ti–6.25at.%Nb alloys
Martensitic transformation is an important deformation mechanism in titanium alloys. Using density functional theory calculations, we establish the lattice constants and the associated energetics of the bcc–hcp transformation in Ti–6.25at.%Ta and Ti–6.25at.%Nb alloys. We present a bcc–hcp nucleation model based on the Peierls Nabarro formalism, incorporating the elastic strain energy of the dis...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1999