On the Attainability of Fusion Temperatures under High Densities by Impact Shock Waves of Small Solid Particles
ثبت نشده
چکیده
In this paper it is shown that temperatures up to 108 ° K and under densities of the order 1 g/cm3 are attainable in liquid tritium-deuterium by the impact shock waves of small solid particles accelerated up to velocities of some 107 cm/s in heavy particle accelerators. The high temperatures occur in a focussed particle beam. It is shown that under feasible conditions, the particle beam will generate in the target material a shock wave of the required strength. The particles are charged electrically up to the limit of mechanical breakup and then are accelerated in linear particle accelerators to the required velocities. In order to cut down losses by Bremsstrahlung radiation, the particles must consist of low Zvalue material. The most promissing substances in this regard are lithium and beryllium. The "guillotine factor" is of significance at high densities and reduces the Bremsstrahlung losses by a factor of about 1/3. The attainable temperatures are high enough to reach the lowest ignition temperatures for thermonuclear reactions. Apart from the interesting prospect of high temperature, high density experiments, the possibility cannot be excluded to ignite by this method a small fusion explosion of controllable size.
منابع مشابه
Interparticle collisions driven by ultrasound.
Ultrasound has become an important synthetic tool in liquid-solid chemical reactions, but the origins of the observed enhancements remained unknown. The effects of high-intensity ultrasound on solid-liquid slurries were examined. Turbulent flow and shock waves produced by acoustic cavitation were found to drive metal particles together at sufficiently high velocities to induce melting upon coll...
متن کاملA MODIFIED COMPRESSIBLE SMOOTHED PARTICLE HYDRODYNAMICS (MCSPH) METHOD AND ITS APPLICATION ON THE NUMERICAL SIMULATION OF LOW AND HIGH VELOCITY IMPACTS
In this study a Modified Compressible Smoothed Particle Hydrodynamics (MCSPH) method is introduced which is applicable in problems involve shock wave structures and elastic-plastic deformations of solids. As a matter of fact, algorithm of the method is based on an approach which descritizes the momentum equation into three parts and solves each part separately and calculates their effects on th...
متن کاملبررسی حساسیت به موج شوک و ضربه در پیشرانههای جامد مرکب
In this paper, the factors effecting the shock wave and impact Sensitivity such as oxygen balance, porosity, components particle size in composite solid propellants have been investigated. The energetic components of propellants such as oxidizer and fuel usually effect shock wave sensitivity and changing in composition, particle size and manufacturing process, determine the sensitivity property...
متن کاملInfluence of electroplating parameters on microstructure and amount of ceramic particle deposition in Ni-Co-CeO2-ZrO2 composite coating
Austenitic stainless steels are high performance steels that have various applications in solid oxide fuel cells and boiler tubes under high temperature operating conditions. The Cr2O3 oxide layer formed on the steel surface becomes unstable at high temperatures and reduces the oxidation resistance of the steel. Therefore, protection of these steels at high temperatures is essential. Therefore,...
متن کاملSegregation Behaviour of Particles in Gas Solid Fluidized Beds at Elevated Pressure
A comprehensive mathematical model based on the discrete particle model and computational fluid dynamics was utilized to investigate mixing and segregation of particles in fluidized beds at high pressure. To quantify the extent of mixing in the bed, the Lacey mixing index was used. Simulations were carried out with different mass fractions of small particles at various pressures ranging from 1 ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2012