A Unified Behavioral Average Model of Sepic Converters with Coupled Inductors

نویسندگان

  • D. Adar
  • G. Rahav
  • S. Ben-Yaakov
چکیده

An average model of SEPIC converters with coupled or uncoupled inductors was developed and verified against cycle-by-cycle s i m u l a t i o n s . The model can be used as-is by any modern circuit simulator to run steady state (DC), large signal (transient) and small signal (AC) analyses. The leakage inductances were taken into account and treated separately from the mutual inductance. The primary and secondary coupling coefficients were incorporated as parameters in the model. The coupling coefficients can be set to a value from zero to almost one, representing the complete range o f poss ib le SEPIC topo log ies . a transformer, in the sense that current flows on both sides at the same time, while both sides are loaded by capacitors (Cfi, Cs and Cp, Fig. 1). The same modeling problem appears in other topologies with coupled inductors (e.g. C'uk converter). A general modeling solution, suitable for coupled inductors converters, is proposed in this paper. The average modeling methodology [3, 4] used here hinges on the observation that by continuously applying the running average voltage (for a window of one switching period) across an inductor, the inductor will produce a running averaged current. The same reasoning applies to switched capacitors. Namely, by injecting the running average current into a capacitor, the capacitor will be charged to the running averaged voltage. This observation is based on the assumption that the switching frequency is much higher than the power stage bandwidth. Therefore, the average voltages across the capacitors and average currents through the inductors do not change appreciably during one switching period. Namely, the voltages and currents that will be produced by the average model of the proposed methodology are the ripple-less values, as if we have operated the switch at infinite frequency but with the same duty cycle values.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Behavioral Average Model of Sepic Converters with Coupled Inductors

An average model of SEPIC converters with coupled inductors was developed and verified against cycle-by-cycle simulations. The model can be used as-is by any modern circuit simulator to run steady state (DC), large signal (Transient) and small signal (AC) analyses. The inductors coupling coefficient, incorporated as a parameter in the model, can be varied from zero to almost unity. Zero couplin...

متن کامل

A Steady-state Analysis of PWM SEPIC Converter

The paper presents a unified steady-state analysis of PWM SEPIC converter with coupled inductors and separate inductors for both continuous and discontinuous conduction modes. The results of this simplified analysis allow to determine the operating point of converters and further the small-signal low-frequency parameters of linear model, and to design the converter too. The expressions of all s...

متن کامل

Design and Analysis of Multiphase Dc-dc Converters with Coupled Inductors

Design and Analysis of Multiphase DC-DC Converters with Coupled Inductors. (May 2007) Meng Shi, B.Eng., Shanghai Jiao Tong University, China Chair of Advisory Committee: Dr. Prasad Enjeti In this thesis, coupled inductors have been applied to multiphase DC-DC converters. Detailed analysis has been done to investigate the benefits of directly coupled inductors and inversely coupled inductors, co...

متن کامل

An Interleaved Configuration of Modified KY Converter with High Conversion Ratio for Renewable Energy Applications; Design, Analysis and Implementation

In this paper, a new high efficiency, high step-up, non-isolated, interleaved DC-DC converter for renewable energy applications is presented. In the suggested topology, two modified step-up KY converters are interleaved to obtain a high conversion ratio without the use of coupled inductors. In comparison with the conventional interleaved DC-DC converters such as boost, buck-boost, SEPIC, ZETA a...

متن کامل

Design Criteria for Sepic and Cuk Converters as Power Factor Preregulators in Discontinuous Conduction Mode

Power Factor Preregulators (PFP) have been used to improve input current waveform of off-line power supplies. There are two major approaches in implementing control circuits in PFP: the multiplier approach and the voltage-follower approach. The simplest one is the voltage-follower approach because the converter operates in discontinuous conduction mode (DCM), and only one loop control is requir...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 1999