Crystallization of Poly(3-hexylthiophene) Nanofiber in a Narrow Groove

نویسندگان

  • Satoshi Kushi
  • Ryota Tsukada
  • Keiichi Noguchi
  • Takeshi Shimomura
  • Hsing-Lin Wang
چکیده

Whisker-type poly(3-hexylthiophene-2,5-diyl) (P3HT) nanofibers were aligned by restricting their growth direction using an approximately 100–1000 nm wide narrow groove fabricated by thermal nanoimprinting. In grooves made of an amorphous fluoropolymer (CYTOPTM) with widths of less than 1500 nm, the nanofibers oriented uniaxially perpendicular to the groove and their length was limited to the width of the groove. This result indicates that the nucleation of nanofibers tends to be selectively promoted near the interface of CYTOPTM with fluoro-groups, and nanofiber growth perpendicular to the wall is promoted because P3HT molecules are supplied more frequently from the center of the groove. Furthermore, the orientation induced anisotropic conductivity, and the conductivity parallel to the oriented nanofibers was more than an order of magnitude higher than that perpendicular to the oriented nanofibers.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Thermoelectric Properties of Poly(3-Hexylthiophene) Nanofiber Mat with a Large Void Fraction

The thermoelectric properties of a poly(3-hexylthiophene) (P3HT) nanofiber mat which has higher crystallinity-and thus exhibits larger carrier mobility-than a non-fibrous P3HT film, were investigated. No significant difference was observed in the maximum values of the power factor between the P3HT nanofiber mat and the P3HT film. However, the thermal conductivity of the nanofiber mat was less t...

متن کامل

Effect of TiO2 Nanofiber Density on Organic-Inorganic Based Hybrid Solar Cells (RESEARCH NOTE)

Abstract In this work, a comparative study of hybrid solar cells based on P3HT and TiO2 nanofibers was accomplished. Electrospinning, a low cost production method for large area nanofibrous films, was employed to fabricate the organic-inorganic hybrid solar cells based on poly (3-hexylthiophene) and TiO2 nanofibers. The performance of the hybrid solar cells was analyzed for four density levels ...

متن کامل

Ordering of poly(3-hexylthiophene) in solution and on substrates induced by concentrated sulfuric acid.

The ordering of poly(3-hexylthiophene) (P3HT) molecules in dilute P3HT/chloroform solutions was accelerated by adding small amounts of concentrated H2SO4. The concentrated H2SO4 stimulates the nucleation of crystals, which controls the overall rate of P3HT crystallization. Dispersed nuclei spur P3HT solution crystallization, and adsorbed nuclei induce P3HT crystallization on substrates. By AFM,...

متن کامل

Two-dimensional MoS2-assisted immediate aggregation of poly-3-hexylthiophene with high mobility.

Nanoscale morphology is of significance to the electronic properties of semiconducting polymers. Solution-processed poly-3-hexylthiophene (P3HT) has been demonstrated as a promising active-layer material in organic thin film transistors (OTFTs) and solar cells. Controlling the crystallinity of P3HT chains is critical for gaining high-performance devices. Here we demonstrated the immediate cryst...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2016