Lunar Surface Mechanical Properties
نویسنده
چکیده
The surface material at the Surveyor 5 site is granular and slightly cohesive. Spacecraft footpads plowed trenches in this material as the spacecraft slid during landing. For a compressible soil model, a static bearing capacity of 2.7 newtons/cm •' gave best agreement with the observations. Static firing of the vernier engines against the surface moved surface particles; a crater 20 cm in diameter and about 1 cm deep was produced, apparently at engine shutdown. The permeability of the soil to gases, to a depth of about 25 cm, is 1 X 10 -s cm .ø, corresponding to soil particles mostly 2 to 60 t• in diameter.
منابع مشابه
Grain-scale mechanical properties of lunar plagioclase and its simulant: Initial experimental findings and modeling implications
Preparations for lunar missions involve the extensive use of simulants of lunar surface materials. Since many planned operations engage the mechanical properties of the regolith, it is of utmost importance to assure that the simulants adequately represent the engineering properties of actual lunar materials. To address this critical issue, we are conducting an experimental and modeling effort t...
متن کاملPhysical Properties of the Lunar Surface
This chapter discusses the physical properties of the lunar surface, determined at depths varying from a few micrometers to a few tens of meters. The properties considered include geotechnical properties (those properties of a planetary surface needed to evaluate engineering problems, including the mechanical properties of soil and rock), electrical and electromagnetic properties, and the refle...
متن کاملRecent Developments on a Simulator for Lunar Surface Operations
New models and capabilities in the Jet Propulsion Laboratory’s (JPL) Lunar Surface Operations Simulator (LSOS) are reported in this paper. LSOS is a simulator built to support surface operations design and planning for future lunar missions. LSOS models surface systems, their mechanical properties, and operations. In addition to simulating the dynamic interactions during operations, for example...
متن کاملDevelopment of near-zero water consumption cement materials via the geopolymerization of tektites and its implication for lunar construction
The environment on the lunar surface poses some difficult challenges to building long-term lunar bases; therefore, scientists and engineers have proposed the creation of habitats using lunar building materials. These materials must meet the following conditions: be resistant to severe lunar temperature cycles, be stable in a vacuum environment, have minimal water requirements, and be sourced fr...
متن کاملA Virtual Simulation Environment for Lunar Rover: Framework and Key Technologies
Lunar rover development involves a large amount of validation works in realistic operational conditions, including its mechanical subsystem and on-board software. Real tests require equipped rover platform and a realistic terrain. It is very time consuming and high cost. To improve the development efficiency, a rover simulation environment called RSVE that affords real time capabilities with hi...
متن کاملGeochemistry of the lunar highlands as revealed by measurements of thermal neutrons
Thermal neutron emissions from the lunar surface provide a direct measure of bulk elemental composition that can be used to constrain the chemical properties of near-surface (depth <1 m) lunar materials. We present a new calibration of the Lunar Prospector thermal neutron map, providing a direct link between measured count rates and bulk elemental composition. The data are used to examine the c...
متن کامل