On the formation of fold-type oscillation marks in the continuous casting of steel
نویسندگان
چکیده
Asymptotic methods are employed to revisit an earlier model for oscillation-mark formation in the continuous casting of steel. A systematic non-dimensionalization of the governing equations, which was not carried out previously, leads to a model with 12 dimensionless parameters. Analysis is provided in the same parameter regime as for the earlier model, and surprisingly simple analytical solutions are found for the oscillation-mark profiles; these are found to agree reasonably well with the numerical solution in the earlier model and very well with fold-type oscillation marks that have been obtained in more recent experimental work. The benefits of this approach, when compared with time-consuming numerical simulations, are discussed in the context of auxiliary models for macrosegregation and thermomechanical stresses and strains.
منابع مشابه
Visualization of Hook and Oscillation Mark Formation Mechanism in Ultra-Low Carbon Steel Slabs During Continuous Casting
Oscillation marks accompanied by sub-surface hooks routinely appear on the surface of continuously cast steel slabs, and are especially severe in ultralow carbon steel. This paper presents a new detailed mechanism for their formation, which has been developed by combining existing theoretical modeling results, experimental observations, and analyses based on optical and scanning electron micros...
متن کاملA New Mechanism of Hook Formation during Continuous Casting of Ultra-Low-Carbon Steel Slabs
The initial stages of solidification near the meniscus during continuous casting of steel slabs involve many complex inter-related transient phenomena, which cause periodic oscillation marks (OMs), subsurface hooks, and related surface defects. This article presents a detailed mechanism for the formation of curved hooks and their associated OMs, based on a careful analysis of numerous specially...
متن کاملPrediction of Grain Size, Precipitation and Crack Susceptibility in Continuous Casting
The formation of precipitates, especially along austenite grain boundaries, greatly affects the formation of transverse cracks on the surface of continuous-cast steel. The steel composition and cooling history influences the formation of precipitates, and the higher temperature and corresponding larger grain growth rate under oscillation marks or surface depressions also have an important effec...
متن کاملMathematical Simulation for the Effects of Flow Control Devices in a Six- strand Tundish in Continuous Casting of Steel Billet
The method of continuous casting of steel is now often used in the metallurgical industry, due to the increasing demand for the production of high – quality steel. An important device of continuous casting machine is the tundish, in which a stabilized steel flow has a crucial effect on the quality and efficiency conditions of the continuous casting process. In this study fluid flows in a six – ...
متن کاملMechanism of Hook Formation in Ultra-low Carbon Steel based on Microscopy Analysis and Thermal-stress Modeling
Periodic transverse depressions called “oscillation marks” are routinely observed on the surface of steel slabs manufactured by continuous casting processes. Additionally, a distinctive sub-surface microstructural feature called a “hook” 4, 5) often accompanies deep oscillation marks in steels with low (< 0.1%) carbon contents . Figure 1 shows typical shapes and sizes of oscillation marks and h...
متن کامل