Multifluid flow in bedded porous media: laboratory experiments and numerical simulations

Understanding light nonaqueous-phase liquid (LNAPL) movement in heterogeneous vadose environments is important for effective remediation design. We investigated LNAPL movement near a sloping fineover coarse-grained textural interface, forming a capillary barrier. LNAPL flow experiments were performed in a glass chamber (50 cm 3 60 cm 3 1.0 cm) using two silica sands (12/20 and 30/40 sieve sizes). Variable water saturations near the textural interface were generated by applying water uniformly to the sand surface at various flow rates. A model LNAPL (Soltrolt 220) was subsequently released at two locations at the sand surface. Visible light transmission was used to quantitatively determine water saturations prior to LNAPL release and to observe LNAPL flow paths. Numerical simulations were performed using the Subsurface Transport Over Multiple Phases (STOMP) simulator, employing two nonhysteretic relative permeability–saturation–pressure (k–S–P) models. LNAPL movement strongly depended on the water saturation in the fine-grained sand layer above the textural interface. In general, reasonable agreement was found between observed and predicted water saturations near the textural interface and LNAPL flow paths. Discrepancies between predictions based on the van Genuchten/ Mualem (VGM) and Brooks–Corey/Burdine (BCB) k–S–P models existed in the migration speed of the simulated LNAPL plume and the LNAPL flow patterns at high water saturation above the textural interface. In both instances, predictions based on the BCB model agreed better with experimental observations than predictions based on the VGM model. The results confirm the critical role water saturation plays in determining LNAPL movement in heterogeneous vadose zone environments and that accurate prediction of LNAPL flow paths depends on the careful selection of an appropriate k–S–P model. q 1998 Elsevier Science Limited. All rights reserved