Core-in-shell sorbent for hot coal gas desulfurization
نویسنده
چکیده
A core-in-shell sorbent is described herein. The core is reactive to the compounds of interest, and is preferably calcium-based, such as limestone for hot gas desulfurization. The shell is a porous protective layer, preferably inert, which allows the reactive core to remove the desired compounds while maintaining the desired physical characteristics to withstand the conditions of use.
منابع مشابه
Microstructure contradistinction for indirect/direct desulfurization product layer of limestone particle in coal-fired flue gas
The micro morphology of limestone sorbent is a key for improving the SO2 removal efficiency in the coal-fired power plant. The tube furnace system was built for imitating the indirect desulfurization reaction in traditional boiler atmosphere (65%N2, 15%CO2, 4.7%O2, 15%H2O, 0.3%SO2) and the direct desulfurization reaction in oxygen-fired atmosphere (80%CO2, 4.7%O2, 15%H2O, 0.3%SO2). The reacted ...
متن کاملMeasurement of Mercury in Flue Gas Based on an Aluminum Matrix Sorbent
The measurement of total mercury in flue gas based on an economical aluminum matrix sorbent was developed in this paper. A sorbent trap consisted of three tubes was employed to capture Hg from flue gas. Hg trapped on sorbent was transferred into solution by acid leaching and then detected by CVAAS. Hg adsorbed on sorbent was recovered completely by leaching process. The 87.7% recovery of Hg in ...
متن کاملDevelopment of a combined catalyst and sorbent for the water gas shift reaction
A combined catalyst and sorbent was developed for reacting CO with steam to produce H2 in a single reaction stage at 600 °C by employing the water gas shift (WGS) reaction. The combined material was in the form of spherical pellets where each pellet consisted of a CaO core for absorbing byproduct CO2 surrounded by a porous shell of Al2O3 which supported a Ni catalyst. The best results were achi...
متن کاملFlue gas desulfurization
Flue gas desulfurization is commonly known as FGD and is the technology used for removing sulfur dioxide (SO2) from the exhaust combustion flue gases of power plants that burn coal oroil to produce steam for the turbines that drive their electricity generators. The most common types of FGD contact the flue gases with an alkaline sorbent such as lime or limestone. As sulfur dioxide is responsibl...
متن کامل