Pharmaceutical Microencapsulation Technology for Development of Controlled Release Drug Delivery systems

This article demonstrated development of controlled release system of an NSAID drug, Diclofenac sodium employing different ratios of Ethyl cellulose. Diclofenac sodium and ethyl cellulose in different proportions were processed by microencapsulation based on phase separation technique to formulate microcapsules. The prepared microcapsules were then compressed into tablets to obtain controlled release oral formulations. In-vitro evaluation was performed by dissolution test of each preparation was conducted in 900 ml of phosphate buffer solution of pH 7.2 maintained at 37 ± 0.5 °C and stirred at 50 rpm. At predetermined time intervals (0, 0.5, 1.0, 1.5, 2, 3, 4, 6, 8, 10, 12, 16, 20 and 24 hrs). The drug concentration in the collected samples was determined by UV spectrophotometer at 276 nm. The physical characteristics of diclofenac sodium microcapsules were according to accepted range. These were off-white, free flowing and spherical in shape. The release profile of diclofenac sodium from microcapsules was found to be directly proportional to the proportion of ethylcellulose and coat thickness. The in-vitro release pattern showed that with ratio of 1:1 and 1:2 (drug: polymer), the percentage release of drug at first hour was 16.91 and 11.52 %, respectively as compared to 1:3 which is only 6.87 % with in this time. The release mechanism followed higuchi model for its release pattern. Tablet Formulation (F2) of present study was found comparable in release profile the marketed brand Phlogin-SR, microcapsules showed an extended release beyond 24 h. Further, a good correlation was found between drug release and proportion of ethylcellulose in the microcapsules. Microencapsulation based on coacervation found as good technique to control release of diclofenac sodium for making the controlled release formulations. Keywords—Diclofenac sodium, Microencapsulation technology, Ethylcellulose, In-Vitro Release Profile Mahmood Ahmad is the Dean of Faculty of Pharmacy and Alternative Medicine, the Islamia University of Bahawalpur-Pakistan. (Phone: +92-3009682258; fax: +92-62-9255565; e-mail: [email protected]. Remaining co-authors are from the Department of Pharmacy, Faculty of Pharmacy and Alternative Medicine, the Islamia University of BahawalpurPakistan. (phone: +92-62-9255243; fax: +92-62-9255565; e-mail: [email protected], [email protected], [email protected], [email protected],