Wear Neutral - Current Interactions
نویسنده
چکیده
منابع مشابه
NEW INTERACTIONS IN NEUTRAL CURRENT PROCESSESa
Measurements of neutral current processes oo the Z-peak are sensitive probes of new interactions, which may be induced by the exchange of new particles such as leptoquarksor extra Z's. This talk reviews the phenomenologyof extra interactions in four-fermion processes and updates a global t to contact terms in the neutral current sector.
متن کاملDRILL WEAR PREDICTION SYSTEM USING OF MOTOR CURRENT AND FUZZY LOGIC METHOD
In automation flexible manufacturing systems, tool wear detection during the cutting process is one of the most important considerations. This study presents an intelligent system for online tool condition monitoring in drilling process .In this paper, analytical and empirical models have been used to predict the thrust and cutting forces on the lip and chisel edges of a new drill. Also an empi...
متن کاملCervical Artificial Disc Wear: the Influence of Surgical Placement
Relative motion at interacting implant surfaces generates wear debris over time leading to periprosthetic osteolysis and device failure. Factors related to implant design, patient habitus and surgical approach will impact the generation of wear debris and influence the clinical longevity of artificial spinal disc devices. Further, surgeons play an important role in selecting the appropriate imp...
متن کاملWear behavior of carbon steel electrodeposited by nanocrystalline Ni–W coating
Ni-W coatings, compared to pure nanocrystalline Ni, exhibit higher hardness and wear resistance. In some cases, these coatings are considered as environmental friendly alternatives for hard chromium coating. Till now, most of Ni-W coatings have been produced by direct current electrodeposition from alkaline baths. In this study square pulse current was used for deposition of Ni-W precipitates f...
متن کاملOn the Physics of Machining Titanium Alloys: Interactions between Cutting Parameters, Microstructure and Tool Wear
The current work deals with the analysis of mechanisms involved during the machining process of titanium alloys. Two different materials were chosen for the study: Ti-6Al-4V and Ti-55531. The objective was to understand the effect of all cutting parameters on the tool wear behavior and stability of the cutting process. The investigations were focused on the mechanisms of the chip formation proc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1978