Influence of Si-Doping of Nano-Ni Dispersed Al2O3 Composites on High-Temperature Oxidation

نویسندگان

  • Daisuke Maruoka
  • Makoto Nanko
چکیده

The oxidation kinetics of 5 vol% nano-Ni dispersed Al2O3 with Si-doping (nano-Ni/Al2O3-Si) was studied in the present paper. The starting powder mixture was prepared by drying aqueous slurry consisting of alumina with nickel nitrate and Si (OCH3)4. The powder mixture was reduced at 600 C for 12 h in a stream of Ar-1%H2 gas mixture. Nano-Ni/Al2O3-Si was densified by pulsed electric current sintering. The oxidation test was conducted at 1200–1350 C for 1–14 d in air. Oxidized zone consisted of Al2O3 matrix and NiAl2O4 as the oxidation product. Growth of the oxidized zone followed a parabolic manner. A thin NiAl2O4 layer was also observed on the sample surface. Si-doping decreases growth rate of oxidized zone effectively at lower temperatures such 1200 C. [doi:10.2320/matertrans.MAW201027]

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Grain size influence on the thermal properties of stabilized zirconia-nano spinel (Al2O3-MgO) composites

Abstract. Cubic crystalline oxides such as Y2O3 and MgO is used to stabalized zirconia phases at high temperature. In this paper the Y2O3 powder was added to stabilized zirconia and preparing a mixture of MgAl2O4 Spinel by mixing 1mol of nano-MgO with 1 mol of nano-Al2O3 powders. The spinel was added to the Y2O3-ZrO2 by various weight percentage (5, 10, 15, 20 and 25 wt%), and after that the sp...

متن کامل

Thermoelectric Properties of Alumina-Doped Bi0.4Sb1.6Te3 Nanocomposites Prepared through Mechanical Alloying and Vacuum Hot Pressing

In this study, γ-Al2O3 particles were dispersed in p-type Bi0.4Sb1.6Te3 through mechanical alloying to form γ-Al2O3/Bi0.4Sb1.6Te3 composite powders. The composite powders were consolidated using vacuum hot pressing to produce nanoand microstructured composites. Thermoelectric (TE) measurements indicated that adding an optimal amount of γ-Al2O3 nanoparticles improves the TE performance of the fa...

متن کامل

Fsw Of Polypropylene Reinforced With Al2o3 Nano Composites, Effect On Mechanical And Microstructural Properties

Friction stir welding is a solid state joining process first used for welding of Aluminum and its alloys, is now employed for welding of polymers and composite materials. Polypropylene (pp) is one of polymer materials used in many applications due to its good performance, high strength to weight ratio and excellent processing properties, its application is limited due to its weak abrasive prope...

متن کامل

Investigation of composite powder synthesis (Al2O3-WXSiY-WXBY) in aluminothermic combustion system (Al+B2O3+Si+WO3) using thermal analysis

Composites that are including silicide of tungsten and boride of tungsten intermetallic compound have properties such as high hardness, relatively good thermal shock, chemical stability and high strength at high temperature. The purpose of this investigation is evaluation of phase and microstructure of alumina base composite reinforced by boride and silicide of tungsten in three systems 1-Al+...

متن کامل

The Study of High Temperature Oxidation behavior of Different Microstructures of HVOF Thermally Sprayed Coatings

Improvement of thermally sprayed coating properties by microstructure modification has been considered as a significant solution. Therefore, in this research the effect of dissolved oxygen content and post heat treatment on the formation and distribution of secondary phase particles, particularly in nano-scale in the coatings during spraying and after that were studied. Ni-5 wt% Al powders were...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2010