Bending Properties of Cross Laminated Timber (CLT) with a 45° Alternating Layer Configuration
نویسندگان
چکیده
Bending tests were conducted with cross laminated timber (CLT) panels made using an alternating layer arrangement. Boards of Norway spruce were used to manufacture five-layer panels on an industrial CLT production line. In total, 20 samples were tested, consisting of two CLT configurations with 10 samples of each type: transverse layers at 45° and the conventional 90° arrangement. Sample dimensions were 95 mm × 590 mm × 2000 mm. The CLT panels were tested by four point bending in the main load-carrying direction in a flatwise panel layup. The results indicated that bending strength increased by 35% for elements assembled with 45° layers in comparison with 90° layers. Improved mechanical load bearing panel properties could lead to a larger span length with less material.
منابع مشابه
Structural Tests of Concrete Composite - Cross - Laminated Timber Floors Final Report
Experimental tests of a composite concrete-cross-laminated timber (CLT) floor system were conducted. The floor system was constructed with 5-ply CLT panels (6.75 in. thick) made composite with a 2.25 in. thick reinforced concrete topping slab. Four series of tests were performed using different specimen configurations and laboratory testing methods. Tests included: (1) Comparative one-way bendi...
متن کاملA Comparison of the Energy Saving and Carbon Reduction Performance between Reinforced Concrete and Cross-Laminated Timber Structures in Residential Buildings in the Severe Cold Region of China
This paper aims to investigate the energy saving and carbon reduction performance of cross-laminated timber residential buildings in the severe cold region of China through a computational simulation approach. The authors selected Harbin as the simulation environment, designed reference residential buildings with different storeys which were constructed using reinforced concrete (RC) and cross-...
متن کاملAssessing Cross Laminated Timber (CLT) as an Alternative Material for Mid-Rise Residential Buildings in Cold Regions in China—A Life-Cycle Assessment Approach
Timber building has gained more and more attention worldwide due to it being a generic renewable material and having low environmental impact. It is widely accepted that the use of timber may be able to reduce the embodied energy of a building. However, the development of timber buildings in China is not as rapid as in some other countries. This may be because of the limitations of building reg...
متن کاملAnalysis of acoustical behavior of bare cross laminated timber floors for the evaluation of the improvement of impact sound insulation
The estimation of impact sound insulation of horizontal partitions, evaluated from the performance of basic components using EN 12354-2 Standard, do not actually provides satisfactory results when applied to the floors realized with cross laminated timber (CLT) elements. Among the possible reasons of this limited correspondence between predicted and measured impact noise values, one of the most...
متن کاملComparison of Different Assembling Techniques Regarding Cost, Durability, and Ecology - A Survey of Multi-layer Wooden Panel Assembly Load-Bearing Construction Elements
Wood is a pure, sustainable, renewable material. The increasing use of wood for construction can improve its sustainability. There are various techniques to assemble multi-layer wooden panels into prefabricated, load-bearing construction elements. However, comparative market and economy studies are still scarce. In this study, the following assembling techniques were compared: laminating, naili...
متن کامل