Interactions between Oxygen Permeation and Homogeneous-phase Fuel Conversion on the Sweep Side of an Ion Transport Membrane

نویسندگان

  • Patrick Kirchen
  • Ahmed F. Ghoniem
  • Jongsup Hong
چکیده

The interactions between oxygen permeation and homogeneous fuel oxidation reactions on the sweep side of an ion transport membrane (ITM) are examined using a comprehensive model, which couples the dependency of the oxygen permeation rate on the membrane surface conditions and detailed chemistry and transport in the vicinity of the membrane. We assume that the membrane surface is not catalytic to hydrocarbon or syngas oxidation. Results show that increasing the sweep gas inlet temperature and fuel concentration enhances oxygen permeation substantially. This is accomplished through promoting oxidation reactions (oxygen consumption) and the transport of the products and reaction heat towards the membrane, which lowers the oxygen concentration and increases the gas temperature near the membrane. Faster reactions at higher fuel concentration and higher inlet gas temperature support substantial fuel conversion and lead to a higher oxygen permeation flux without the contribution of surface catalytic activity. Beyond a certain maximum in the fuel concentration, extensive heat loss to the membrane (and feed side) reduces the oxidation kinetic rates and limits oxygen permeation as the reaction front reaches the membrane. The sweep gas flow rate and channel height have moderate impacts on oxygen permeation and fuel conversion due to the residence time requirements for the chemical reactions and the location of the reaction zone relative to the membrane surface. ∗ Corresponding author. Tel.: +1 617 253 2295; Fax: +1 617 253 5981 Email address: [email protected] (Ahmed F. Ghoniem)

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Numerical Simulation of Ion Transport Membrane Reactors: Oxygen Permeation and Transport and Fuel Conversion

Ion transport membrane (ITM) based reactors have been suggested as a novel technology for several applications including fuel reforming and oxy-fuel combustion, which integrates air separation and fuel conversion while reducing complexity and the associated energy penalty. To utilize this technology more effectively, it is necessary to develop a better understanding of the fundamental processes...

متن کامل

The coupling effect of gas-phase chemistry and surface reactions on oxygen permeation and fuel conversion in ITM reactors

The effect of the coupling between heterogeneous catalytic reactions supported by an ion transport membrane (ITM) and gas-phase chemistry on fuel conversion and oxygen permeation in ITM reactors is examined. In ITM reactors, thermochemical reactions take place in the gas-phase and on the membrane surface, both of which interact with oxygen permeation. However, this coupling between gas-phase an...

متن کامل

Water Management in the Cathode Side of a PEM Fuel Cell

A one dimensional isothermal mathematical modeling of cathode side of a Proton Exchange Membrane (PEM) fuel cell is developed for the water management problem. Water transport is investigated in both cathode Gas Diffusion Layer (GDL) and membrane through solving appropriate equations for fluid flow and mass transport in GDL and water transport within the membrane. The gaseous mixture flowing in...

متن کامل

Hybrid Molten/Solid In2O3-Bi2O3 Oxygen Ion Transport Membranes

The hybrid molten/solid In2O3 - 30-48 wt.% Bi2O3 oxide materials were studied with respect to their transport properties. The conductivities, oxygen ion transport numbers and oxygen permeation fluxes have been measured by using the four-probe DC, volumetric measurements of the faradaic efficiency and gas flow techniques, respectively. We show that the...

متن کامل

Investigation of ion transport and water content properties in anion exchange membranes based on polysulfone for solid alkaline fuel cell application

In present research work, homogeneous anion exchange membranes based on polysulfone (QAPSFs) were prepared via chloromethylation, amination and alkalization. In amination step, trimethylamine and N,N,N',N'-tetramethyl-1,6-hexanediamine were used as amination and crosslinking agents, respectively. The chloromethylated polysulfone was characterized by 1HNMR spectroscopy and chloromethylation degr...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2012