Cyclic Deformation of Hastelloy and Inconel Alloys and Slip Bands Formation
نویسنده
چکیده
Hastelloy C22 and Inconel 600 and 601 alloys specimens were cyclically deformed. Specimens were sectioned and investigated. Results indicated that the grain structure of Hastelloy C22 revealed planar slip bands, whereas Inconel 600 and 601 showed slip bands having triangular ribbon morphology. The triangular ribbon bands were more distinct in Inconel 601 than in Inconel 600.
منابع مشابه
ACOUSTIC EMISSION DURING DEFORMATION OF Al-Li ALLOYS
The relationship between tensile elongation and acoustic emission (AE) detected during compressive deformation of 81-Li and Al-Li-Zr alloys has been investigated for a range of microstructure. For comparison, AE measurements have been carried out for A1-Cu and commercial 7050 alloys. In the polycrystalline binary A1-Li alloys, the most pronounced AE was detected in the underaged condition durin...
متن کاملMechanisms of deformation in gum metal TNTZ-O and TNTZ titanium alloys: A comparative study on the oxygen influence
In this work, Ti–23Nb–0.7Ta–2Zr (TNTZ) and gum metal Ti–23Nb–0.7Ta–2Zr–1.2O (TNTZ-O) alloys were synthesized by cold crucible levitation melting with the objective of investigating the influence of oxygen on the deformation mechanisms. By tensile tests, electron backscatter diffraction, atomic force microscopy and transmission electron microscopy analyses, we showed that the deformation in the ...
متن کاملNickel-based Superalloy Layer Deposited on AISI H13 Hot Tool Steel Base Metal Using Explosion Cladding process
An experimental test was carried out to explosively clad solution annealed Inconel 718 superalloy on quench-tempered AISI H13 hot tool steel. A wavy with vortices interface geometry was obtained from this experiment. A gradual change in the wavelength along the direction of welding was observed which was due to a change in the impact angle, following the plate contacts. In this paper, the exper...
متن کاملSubstructural Alignment during ECAE Processing of an Al-0.1Mg Aluminium Alloy
An investigation has been carried out into the microstructures developed during the early stages of equal channel angular extrusion (ECAE) in a polycrystalline single-phase Al-0.13Mg alloy, with emphasis on the substructural alignment with respect to the die geometry and the crystallographic slip systems, which is essentially related to the grain refinement and texture development during deform...
متن کاملExperimental and Finite Element Analyses of the Hydrostatic Cyclic Expansion Extrusion (HCEE) Process with Back-Pressure
It is generally known that severe plastic deformation processes with back pressure not only apply higher hydrostatic stress and more deformation compared to what a regular process can apply to a workpiece but also prevent surface defects in the workpiece during the process. Hydrostatic cyclic expansion extrusion (HCEE) was developed recently for processing long ultrafine-grained metals and allo...
متن کامل