Nitroxide polymer networks formed by Michael addition: on site-cured electrode-active organic coating.
نویسندگان
چکیده
Highly and homogeneously crosslinked poly(beta-ketoester) networks densely bearing robust nitroxide radicals were prepared via a click-type and stepwise Michael polyaddition. A half-battery cell composed of the thermally-cured radical network coatings displayed a rapid, reversible, and almost stoichiometric redox-activity even with a thickness of ca. 10 mum, which may be applicable as the electrode of organic-based rechargeable devices.
منابع مشابه
Polymerization of Thin Film Polymers
Polymeric coatings such as polyurethanes, acrylic, epoxies and silicones have been used for over 40 years to protect printed wiring boards (PWB) from moisture, handling and environmental influences. Special semiconductor grade polymers have been developed for chip passivation layers. Polyimide became the standard passivation layer for memory chips and other devices needing surface protection fo...
متن کاملOrganic-polymer thin-film transistors for active-matrix flat-panel displays?
Sandrine Martin Michael Hamilton Jerzy Kanicki* Abstract — Organic-polymer-based thin-film transistors (OP-TFTs) look very promising for flexible, large-area, and low-cost organic electronics. In this paper, we describe devices based on spin-coated organic polymer that reproducibly exhibit field-effect mobility values around 5×10–3 cm2/V-sec. We also address fabrication, performance, and stabil...
متن کاملLaser-Induced Carbon Pyrolysis of Electrodes for Neural Interface Systems
The objective of this work is to produce a laser- fabricated polymer-metal-polymer electrode with the merit of a carbon-based coating as the active site. A 10 µm-thick layer of parylene-C is used serving as the insulation layer in which the active site is locally laser-pyrolyzed. Our preliminary results show that the proposed method is promising in terms of fabrication feasibility and desired e...
متن کاملConductive Polythiophene Nanoparticles Deposition on Transparent PET Substrates: Effect of Modification with Hybrid Organic-inorganic Coating (RESEARCH NOTE)
In this work, Poly(ethyleneterephthalate) (PET) substrate was treated using KOH solution and was modified using hybrid O-I coating containing PCL )polycaprolactone( as organic phase and TEOS )tetraethoxysilane( as inorganic phase. The coating was prepared through a sol-gel process and applied on the surface by dip coater. Then, electrically conducting polythiophene (PTh) nanoparticles were depo...
متن کاملPolymer solar cell by blade coating
Polymer bulk hetero-junction solar cells of poly(3-hexylthiophene) (P3HT) donor and (6,6)-phenyl-C61-butyric acid methyl ester (PCBM) acceptor are fabricated by blade coating in toluene solution. Desired donor–acceptor self-organization is achieved without the slow drying process and high boiling point solvent. Power conversion efficiency is 3.8%, much higher than the 2.6% obtained by spin coat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Chemical communications
دوره 46 20 شماره
صفحات -
تاریخ انتشار 2010