Direct Lithography of Rubbery Oste+ Polymer
نویسندگان
چکیده
We present a Rubbery, Off-Stoichiometric Thiol-Ene-epoxy (OSTE+) polymer for direct lithography manufacturing, demonstrate its use in pneumatic pinch microvalves for lab-on-chip applications, test the lithography process achieving pillars of aspect-ratios (a.r.) 1:8, and characterize it’s surface as hydrophilic.
منابع مشابه
Low Gas Permeable and Non-absorbent Rubbery Oste+ for Pneumatic Microvalves
In this paper we introduce a new polymer for use in microfluidic applications, based on the off-stoichiometric thiol–ene-epoxy (OSTE+) polymer system, but with rubbery properties. We characterize and benchmark the new polymer against PDMS. We demonstrate that Rubbery OSTE+: has more than 90% lower permeability to gases compared to PDMS, has little to no absorption of dissolved molecules, can be...
متن کاملBeyond PDMS: off-stoichiometry thiol-ene (OSTE) based soft lithography for rapid prototyping of microfluidic devices.
In this article we introduce a novel polymer platform based on off-stoichiometry thiol-enes (OSTEs), aiming to bridge the gap between research prototyping and commercial production of microfluidic devices. The polymers are based on the versatile UV-curable thiol-ene chemistry but takes advantage of off-stoichiometry ratios to enable important features for a prototyping system, such as one-step ...
متن کاملHigh-resolution Micropatterning of Off-stochiometric Thiol-enes (oste) via a Novel Lithography Mechanism
We present an entirely novel, self-limiting photolithography mechanism in off-stoichiometry thiol-ene (OSTE) polymers enabling high-resolution and high-aspect ratio features. The OSTE polymers have previously been shown to be promising materials for fabrication of microfluidic devices with tailored surface modifications and mechanical properties. We here introduce direct lithography for micropa...
متن کاملLow Temperature “click” Wafer Bonding of Off-stoichiometry Thiol-ene (oste) Polymers to Silicon
INTRODUCTION Common bonding techniques for lab-on-chip (LOC) microfluidic devices require surface bio-functionalization to be performed in-situ after the chip has been packaged due to the bio-incompatible features of the bonding technique, including high temperature requirements (e.g. thermal bonding of thermoplastics), use of organic solvents (e.g. PMMA bonding) or plasma activation (e.g. PDMS...
متن کاملMicro-Structuring of New Materials Combined with Electronic Polymers for Interfaces with Cells
Materials based on novel Off-Stoichiometry Thiol-Ene polymers, abbreviated OSTE, show promising properties as materials for low cost and scalable manufacturing of microand nanosystems such as lab-on-chip devices. The OSTE materials have tunable mechanical properties, offer possibility for low temperature bonding to many surfaces via tunable surface chemistry, and can be used in soft lithography...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2014