Thermoelectric Properties of Poly(3-Hexylthiophene) Nanofiber Mat with a Large Void Fraction
نویسندگان
چکیده
The thermoelectric properties of a poly(3-hexylthiophene) (P3HT) nanofiber mat which has higher crystallinity-and thus exhibits larger carrier mobility-than a non-fibrous P3HT film, were investigated. No significant difference was observed in the maximum values of the power factor between the P3HT nanofiber mat and the P3HT film. However, the thermal conductivity of the nanofiber mat was less than half that of the film despite having almost the same electrical conductivity. This higher thermoelectric property of the nanofiber mat than the film is attributed to the existence of highly effective conducting pathways and a large void fraction, and the result means that the nanofiber mat was a good candidate for use as a thermoelectric material.
منابع مشابه
Effect of TiO2 Nanofiber Density on Organic-Inorganic Based Hybrid Solar Cells (RESEARCH NOTE)
Abstract In this work, a comparative study of hybrid solar cells based on P3HT and TiO2 nanofibers was accomplished. Electrospinning, a low cost production method for large area nanofibrous films, was employed to fabricate the organic-inorganic hybrid solar cells based on poly (3-hexylthiophene) and TiO2 nanofibers. The performance of the hybrid solar cells was analyzed for four density levels ...
متن کاملA Combined Experimental and Theoretical Study of Optoelectronic and Structural Properties of a New Copolymer Based on Polyvinylcarbazole (PVK) and Poly (3-hexylthiophene) (PHT)
In this paper we report on a combination of experimental and theoretical study of a new copolymer based on carbazole and methylthiophene (Cbz-Mth), in their neutral and oxidized states. We discuss the influence of chain length on conformational and optoelectronic properties with the DFT method. Conformational analysis shows that there are no big changes in the structural parameters of neutral o...
متن کاملC0jm00441c 6282..6290
Two low equivalent weight perfluorosulfonic acid (PFSA) polymers (825 EW and 733 EW) were successfully electrospun into nanofibers by adding as little as 0.3 wt% of high molecular weight poly(ethylene oxide) as a carrier polymer. The electrospun fiber morphology transitioned from cylindrical filaments to flat ribbons as the total concentration of PFSA + carrier in solution increased from 5 wt% ...
متن کاملFabrication of Two Polyester Nanofiber Types Containing the Biobased Monomer Isosorbide: Poly (Ethylene Glycol 1,4-Cyclohexane Dimethylene Isosorbide Terephthalate) and Poly (1,4-Cyclohexane Dimethylene Isosorbide Terephthalate)
The thermal and mechanical properties of two types of polyester nanofiber, poly (1,4-cyclohexanedimethylene isosorbide terephthalate) (PICT) copolymers and the terpolyester of isosorbide, ethylene glycol, 1,4-cyclohexane dimethanol, and terephthalic acid (PEICT), were investigated. This is the first attempt to fabricate PICT nanofiber via the electrospinning method; comparison with PEICT nanofi...
متن کامل