To die or not to die—a role for Fork head
نویسنده
چکیده
The precise determination of when and where cells undergo programmed cell death is critical for normal development and tissue homeostasis. Cao et al. (2007; see p. 843 of this issue) report that the Fork head (Fkh) transcription factor, which is essential for the early development and function of the larval salivary glands in Drosophila melanogaster, also contributes to its demise. These authors show that fkh expression in the salivary glands is normally lost at puparium formation, which is approximately 12 h before they undergo massive cell death triggered by the steroid hormone ecdysone, making room for their developing adult counterparts. The loss of Fkh eliminates its role in blocking cell death, allowing for subsequent ecdysone-induced reaper and head involution defective death activator expression and tissue destruction. This study provides new insights into the transcriptional regulation of programmed cell death and the mechanisms that underlie the precise spatial and temporal control of hormone responses during development.
منابع مشابه
Optimization of Axisymmetric Extrusion Die Profiles
In this research, optimization process of axisymmetric extrusion dies is proposed. Plastic zone is analyzed using finite element method in the Eulerian system with flow formulation. The die profiles are defined by Bezier curves with six control points. Two effective functions are considered in this research; standard deviation of the strain rate and the rate of energy consumption during extrusi...
متن کاملSimulation of a New Process Design to Fabricate a Rectangular Twist Waveguide Using Extrusion and a Twist Die
The aim of the present study is to determine the feasibility of making a rectangular twist waveguide used to rotate electromagnetic waves. For this purpose, the process of fabricating an aluminum rectangular twist waveguide was simulated by making use of finite element method and Deform software. The optimum length and angle of the twist die for manufacturing a twist waveguide with inner cross ...
متن کاملExperimental Investigation of Metal Powder Compaction without Using Lubricant
The main objective of this work was to design a novel device for compaction of metal powders so that the green parts could be ejected with applying a negligible force and without the need for any lubricant in either an admixed form or applied to the die wall. For this purpose a 40 mm diameter one-piece die was envisaged which would elastically contracted 0.076 mm before compaction and after com...
متن کاملMulti-criteria Decision Making Approach: selection of Blanking Die Material (TECHNICAL NOTE)
Proper selection of material in manufacturing firms is a vital role of designer depending upon the different era of application. The material selection problem is very complex and challenging task today. Erroneous cull of material frequently leads to astronomically immense cost involution, and finally drives towards unfortunate component or product breakdown. Thus, the designer necessitates dis...
متن کاملO-19: A Comparison of Pelvic Magnetic Resonance Imaging, Trans-Vaginal and Trans-Rectal Sonography with Laparoscopic Findings in The Diagnosis of Deep Infiltrating Endometriosis
Background The performance of TVS, TRS and MRI for the diagnosis of DIE have been separately reported in earlier studies. However, the three methods have not been concurrently compared in terms of their overall performance and classified results as per different anatomical locations of DIE lesions in a large study population. This study was an attempt to compare pelvic magnetic resonance imagin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- The Journal of Cell Biology
دوره 176 شماره
صفحات -
تاریخ انتشار 2007