Roughness models for particle adhesion.
نویسندگان
چکیده
The effects of different surface roughness models on a previously developed van der Waals adhesion model were examined. The van der Waals adhesion model represented surface roughness with a distribution of hemispherical asperities. It was found that the constraints used to define the asperity distribution on the surface, which were determined from AFM scans, varied with scan size and thus were not constant for all surfaces examined. The greatest variation in these parameters occurred with materials that had large asperities or with materials where a large fraction of the surface was covered by asperities. These rough surfaces were modeled with fractals and also with a fast Fourier transform algorithm. When the model surfaces generated using the Fourier transforms are used in the adhesion model, the model accurately predicts the experimentally observed adhesion forces measured with the AFM.
منابع مشابه
Roughness Model for Adhesion Testing of Pharmaceutical Coating Materials
Objective Roughness is the main parameter in interlocking bonding mechanism. Yet there is no model designed to evaluate the effect of surface roughness on adhesion of coating materials in pharmaceutical sciences. Materials and Methods In this study polymethyl metacrylate spherical beads with different sizes were poured into 10 mm mold, then it was pressed by hand screw and finally heated to 141...
متن کاملAdhesion as an interplay between particle size and surface roughness.
Surface roughness plays an important role in the adhesion of small particles. In this paper we have investigated adhesion as a geometrical effect taking into account both the particle size and the size of the surface features. Adhesion is studied using blunt model particles on surfaces up to 10 nm root-mean-square (RMS) roughness. Measurements with particles both smaller and larger than surface...
متن کاملApplication of orthogonal array technique and particle swarm optimization approach in surface roughness modification when face milling AISI1045 steel parts
Face milling is an important and common machining operation because of its versatility and capability to produce various surfaces. Face milling is a machining process of removing material by the relative motion between a work piece and rotating cutter with multiple cutting edges. It is an interrupted cutting operation in which the teeth of the milling cutter enter and exit the work piece during...
متن کاملThe Effects of Shot and Grit Blasting Process Parameters on Steel Pipes Coating Adhesion
Adhesion strength of exterior or interior coating of steel pipes is too important. Increasing of coating adhesion on surfaces can increase the life time of coating, safety factor of transmitting line pipe and decreasing the rate of corrosion and costs. Preparation of steel pipe surfaces before doing the coating process is done by shot and grit blasting. This is a mechanical way to do it. Some e...
متن کاملRoughness Model for Adhesion Testing of Pharmaceutical Coating Materials
Objective Roughness is the main parameter in interlocking bonding mechanism. Yet there is no model designed to evaluate the effect of surface roughness on adhesion of coating materials in pharmaceutical sciences. Materials and Methods In this study polymethyl metacrylate spherical beads with different sizes were poured into 10 mm mold, then it was pressed by hand screw and finally heated to 141...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Journal of colloid and interface science
دوره 280 2 شماره
صفحات -
تاریخ انتشار 2004