Melt infiltration casting of bulk metallic-glass matrix composites
نویسندگان
چکیده
The authors describe a technique for melt infiltration casting of composites with a metallic-glass matrix. We made rods 5 cm in length and 7 mm in diameter. The samples were reinforced by continuous metal wires, tungsten powder, or silicon carbide particulate preforms. The most easily processed composites were those reinforced with tungsten and carbon steel continuous wire reinforcement. The Zr41.2Ti13.8Cu12.5Ni10.0Be22.5 matrix was quenched to a glass after infiltrating the reinforcement. We analyzed the microstructure of the composites by x-ray diffraction and scanning electron microscopy. The measured porosity was less than 3% and the matrix was about 97% amorphous material.
منابع مشابه
Bulk metallic glass matrix composites
Composites with a bulk metallic glass matrix were synthesized and characterized. This was made possible by the recent development of bulk metallic glasses that exhibit high resistance to crystallization in the undercooled liquid state. In this letter, experimental methods for processing metallic glass composites are introduced. Three different bulk metallic glass forming alloys were used as the...
متن کاملProcessing of Bulk Metallic Glass Foams by Melt Infiltration Techniques
Processing of bulk metallic glass (BMG) foams, using melt infiltration techniques, is reported for the first time. Foaming methods based on infiltration of two types of pattern materials are described: investment of a continuous refractory yielding very low relative density structures (5% dense relative to the BMG), and investment of a discontinuous refractory pellet bed yielding higher relativ...
متن کاملThe effect of silicon on the glass forming ability of the Cu47Ti34Zr11Ni8 bulk metallic glass forming alloy during processing of composites
Composites of the Cu47Ti34Zr11Ni8 bulk metallic glass, reinforced with up to 30 vol % SiC particles are synthesized and characterized. Results based on x-ray diffraction, optical microscopy, scanning Auger microscopy, and differential scanning calorimetry ~DSC! are presented. During processing of the composites, a TiC layer forms around the SiC particles and Si diffuses into the Cu47Ti34Zr11Ni8...
متن کاملFabrication and Mechanical Behavior of Ex Situ Mg-Based Bulk Metallic Glass Matrix Composite Reinforced with Electroless Cu-Coated SiC Particles
Magnesium-based bulk metallic glass matrix composites (BMGMCs) have better plasticity than the corresponding bulk metallic glasses (BMGs); however, their strength and density are often compromised due to the fact that the effective reinforcement phase is mostly plastic heavy metal. For lightweight SiC-particle reinforced BMGMCs, interface wettability and the sharpness of the particles often red...
متن کاملProcessing and Properties of Aluminum and Magnesium Based Composites Containing Amorphous Reinforcement: A Review
This review deals with the processing and properties of novel lightweight metal matrix composites. Conventionally, hard and strong ceramic particles are used as reinforcement to fabricate metal matrix composites (MMCs). However, the poor mechanical properties associated with the interfacial de-cohesion and undesirable reactions at (ceramic) particle–(metallic) matrix interface represent major d...
متن کامل