On the Confusion of Planck Feedback Parameters

نویسنده

  • Kyoji Kimoto
چکیده

The Planck feedback parameter λ0 is the most fundamental quantity in the theory of global warming, because the surface temperature change ∆Ts,0 is calculated by— (radiative forcing due to CO2 doubling)/λ0 in the absence of feedbacks other than that of surface temperature change. The following three groups of Planck feedback parameters are found in the literature depending on the choice of temperature Ts and the outgoing long wave radiation (OLR) at the top of atmosphere in equation of λ0 = −4OLR/Ts, which is derived from the Stefan-Boltzmann Law. GROUP A: Ts = 288K and OLR = 231−243W/m2 λ0 = −3.21 − −3.37(W/m2)/K GROUP B: Ts = 255K and OLR = 242W/m2, λ0 = −3.8(W/m2)/K GROUP C: Ts = 288K and OLR = 492−514W/m2 λ0 = −6.8 − −7.1(W/m2)/K This study shows that λ0 of GROUP C is a theoretically relevant choice for Ts and OLR, rather than those of GROUP A and GROUP B, while the IPCC adopted λ0 of GROUP A. Although the surface temperature change ∆ Ts is 3.0K with λ0 = −3.21(W/m2)/K for CO2 doubling when lapse rate ,water vapor, surface albedo and cloud feedbacks are included in the IPCC AR4, it is shown to be 0.5–0.75K with λ0 = −6.8(W/m2)/K in the present study. Since the IPCC overestimates the threat of carbon dioxide by 4–6 times, the revaluation will be needed for the CO2 reduction policies in terms of cost and potential hazards.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The effect of self-control feedback on the learning of generalized motor program and parameters during physical and observational practice

The purpose of this study was to examine the effect of self-control feedback on the learningof generalized motor program and parameters during physical and observational practice. Participants (n=90) were randomly assigned to physical and observational practice (self-control, yoked and instructor KR) groups. They practiced a sequential timing task. The task required participants to press four k...

متن کامل

Numerical Studies and Simulation of the Lower Hybrid Waves Current Drive by using Fokker – Planck Equation in NSST and HT-7 Tokamaks

Recent experiments on the spherical tokamak have discovered the conditions to create a powerful plasma and ensure easy shaping and amplification of stability, high bootstrap current and confinement energy. The spherical tours (ST) fusion energy development path is complementary to the tokamak burning plasma experiment such as NSTX and higher toroidal beta regimes and improves the design of a po...

متن کامل

adaptive control of two-link robot manipulator based on the feedback linearization method and the proposed neural network

This paper proposes an adaptive control method based on the feedback linearization technique and a proposed neural network,  for tracking and position control of an industrial manipulator. At first, it is assumed that the dynamics of the system are known and the control signal is constructed  by the feedback linearization method. Then to eliminate the effects of the uncertainties and external d...

متن کامل

The Effect of Information Rate and Store Environment on Purchasing Value; Analysis of the Role of Confusion and Motivational Tendency

Objective A great number of customers spend much more time than expected on shopping because of a lot of reasons like variety in products. Thus, they may feel confused and disappointed. Such confusion can influence purchasing procedure and determine purchasing behavior. Such customers fail to purchase wisely and may face difficulty choosing appropriate and reasonable products. However, if the ...

متن کامل

Adaptive Speed Control of Three-Phase Induction Servo-drives Based on Feedback Linearization Theory

In this paper, based on feedback linearization control method and using a special PI (propotational integrator) regulator (IP) in combination with a feed-forward controller, a three-phase induction servo-drive is speed controlled. First, an observer is employed to estimate the rotor d and q axis flux components. Then, two input-output state variables are introduced to control the dynamics of to...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2009