Study of Genetic Algorithms on Optimizing PI Parameters in Prime Mover Simulation System

نویسندگان

  • Lixin Tan
  • Juemin Liu
چکیده

This paper proposes using the genetic algorithms to optimize the PI regulator parameter in the prime mover simulation system. In this paper, we compared the step response characteristics under the conditions of the genetic algorithms and traditional method by MATLAB simulation and field test tested the dynamic characteristics of the prime mover simulation system. The results proved that genetic algorithms can optimize PI parameters quickly .With this method the prime mover simulation system can meet the requirements of dynamic performance simulation

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Simulation and Genetic Algorithms for Optimizing Comminution Circuit at Gol-e-Gohar Iron Plant (RESEARCH NOTE)

simulation optimization is a scientific tool that is widely used to design and optimize comminution circuits in mineral processing plants. In this research, first of all, in order to  determine the suitable d80 for cicuit hydrocyclone underflow, the requiremed parameters of simulator (residence time distribution, breakage function, selection function and Plitt’s model calibration) were determin...

متن کامل

اثر مادون سرد کردن مایع خروجی از کندانسور در سیستم‌های تبرید ترکیبی توسط سیکل جذبی آب- آمونیاک

This paper investigates the effects of subcooling the condenser outlet refrigerant in a compression refrigeration by an absorption refrigeration in an integrated refrigeration system from energy view point. For this purpose the thermodynamic system is analyzed, base on the mass and energy equation and also the effects of operating parameters such as prime mover, ambient temperature and evaporat...

متن کامل

Reliability Modelling of the Redundancy Allocation Problem in the Series-parallel Systems and Determining the System Optimal Parameters

Considering the increasingly high attention to quality, promoting the reliability of products during designing process has gained significant importance. In this study, we consider one of the current models of the reliability science and propose a non-linear programming model for redundancy allocation in the series-parallel systems according to the redundancy strategy and considering the assump...

متن کامل

Selection of the optimum prime mover and the working fluid in a regenerative organic rankine cycle

A regenerative organic Rankine cycle (RORC) is modeled and optimized for the use of waste heat recovery from a prime mover (PM). Three PMs including, a diesel engine, a gas engine, and a microturbine are selected in this study. Four refrigerants including isobutane, R123, R134a, and R245fa are selected. The nominal capacity of the PM, PM operating partial load, turbine inlet pressure, condenser...

متن کامل

Speed Control of Induction Motor Supplied by Wind Turbine Using ICA

This paper proposes the design of a Proportional Integral (PI) controller using Imperialist Competitive Algorithm (ICA) to control the speed of an Induction Motor (IM) fed from wind turbine. The wind turbine plays as a prime mover to a connected DC generator. Pulse Width Modulation (PWM) is used to get three phase AC voltage from the output of DC generator. The proposed design problem of speed ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Computer and Information Science

دوره 1  شماره 

صفحات  -

تاریخ انتشار 2008