Error Correction of Co-ordinate Measuring Machines
نویسندگان
چکیده
The paper presents a rigid body kinematic model of the co-ordinate measuring machin. The individual error components are described by means of transformation matrices and the resulting global error is given in the form of twisted space curves. A new techniques for measuring these error components is described. Using these parameters, an error compensation program has been implemented, which has been applied to a suitable three coordinate measuring machine. The results of this research are presented in the subsequent sections.
منابع مشابه
Error Analysis and Correction of a High Precision Co-ordinate Table
A small scale, high precision co-ordinate table was developed as part of a project to solve measurement problems originating from microtechnic. Construction with a single reference surface was selected and vacuum preloaded air bearing applied in order to enable smooth motion and eliminate stick slip. Laser interferometers were applied to measure both the displacement and the angular error. The ...
متن کاملPerformance analysis of partially coherent SSD systems
The performance analysis of a system employing co-ordinate interleaving and constellation rotation, over Nakagami-m fading channels, in the presence of phase noise as well as additive white Gaussian noise, is presented. An upper bound for the average probability of bit error for M-ary phase shift keying is derived. It is shown that the derived upper bound is tight for high signal-to-noise ratio...
متن کاملبررسی میزان خطا در تعیین نقاط سفالومتریک آنالیز Delaire
The architectural and structural analysis of Delaire was developed to evaluate complex craniofacial structures without relating the individual to a so-called normal or average group. This analysis is especially valuable in two regards: first, this analysis is based upon mutual balance of the cranial and facial structures; second, statistical averages are avoided. But , the p...
متن کاملRecommendations for an Acceptance and Verification Test of Optical 3-d Measurement Systems
The paper reports on the development of a new guideline for acceptance and verification of optical 3-D measuring system, e.g. photogrammetric systems or fringe-projection systems. The work has started in 1996, initiated by the working group “Close-range Photogrammetry” of the German Society for Photogrammetry and Remote Sensing (DGPF) and by the working group “Co-ordinate measuring machines” of...
متن کاملValidation of a vision-based, three-dimensional facial imaging system.
OBJECTIVE The aim of this study was to assess the accuracy of a newly developed three-dimensional (3D) imaging system in recording facial morphology. METHODS Twenty-one infants with cleft lip each had a full-face alginate impression taken at the time of primary lip repair, and a stone cast was constructed from each impression. Five anthropometric points were marked on each cast. Each cast was...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2005